TCJB227M004R0070 Datasheet, PDF (7/8 Pages) AVX Corporation – Tantalum Solid Electrolytic Chip Capacitors

TCJ Series
Tantalum Solid Electrolytic Chip Capacitors
with Conductive Polymer Electrode
RATINGS & PART NUMBER REFERENCE
Rated Rated Category Category DCL
DF
ESR
AVX
Case Cap Voltage Temp. Voltage Temp. (μA)
% Max. (mΩ) MSL
Part No.
Size (μF)
(V)
(ºC)
(V)
(ºC) Max. Max. @ 100kHZ
75 Volt @ 85°C
TCJD475M075#0150 D 4.7
75
85
60 105 35.3
6
150
3
TCJD685M075#0120 D 6.8
75
85
60 105 51.0
6
120
3
100 Volt @ 85°C
TCJV685M100#0250 V 6.8 100 85
80 105 68.0
8
250
3
125 Volt @ 85°C
TCJD335M125#0250 D 3.3 125 85 100 105 41.2
8
250
3
100kHz RMS Current (mA)
Product
25ºC 85ºC 105ºC 125ºC Category
1200 800 500
1400 1000 600
1200 800 500
900 600 400
– 105°C
– 105°C
– 105°C
– 105°C
Moinsture Sensitivity Level (MSL) is defined according to J-STD-020.
All technical data relates to an ambient temperature of +25ºC. Capacitance and DF are measured at 120Hz, 0.5RMS with DC bias of 2.2 volts. DCL is measured at
rated voltage after 5 minutes.
ESR allowed to move up to 1.25 times catalog limit post mounting.
For typical weight and composition see page 150.
NOTE: AVX reserves the right to supply a higher voltage rating or tighter tolerance part in the same case size, to the same reliability standards.
PRODUCT CATEGORY 125°C
TEST
Endurance
Storage Life
Humidity
Temperature
Stability
Surge
Voltage
125°C series (Temperature range -55ºC to +125ºC)
Condition
Characteristics
Determine after application of rated voltage for
2000 +48/-0 hours at 85±2ºC and then leaving 1-2
hours at room temperature. Also determine of
125ºC temperature, category voltage for 2000
+48/-0 hours and then leaving 1-2 hours at room
temperature. Power supply impedance to be ≤3Ω.
Visual examination
DCL
ΔC/C
DF
ESR
no visible damage
1.25 x initial limit
within +20/-30% of initial value
1.5 x initial limit
2 x initial limit
Visual examination no visible damage
DCL
2 x initial limit
125ºC, 0V, 2000h
ΔC/C
within ±20% of initial value
DF
1.5 x initial limit
ESR
2 x initial limit
Determine after storage without applied voltage
at 65±2ºC and 95±2% relative humidity for 500
hours and then recovery 1- 2 hours at room
temperature.
Visual examination
DCL
ΔC/C
DF
no visible damage
3 x initial limit
within +30/-20% of initial value
1.5 x initial limit
ESR
2 x initial limit
Step
1
2
3
4
5
6
Temperature°C
+20±2
-55+0/-3
+20±2
+85+3/-0
+125+3/-0
+20±2
Duration(min)
15
15
15
15
15
15
DCL
ΔC/C
DF
+20ºC -55ºC
IL* n/a
n/a +0/-20%
IL* 1.5 x IL*
+20ºC +85ºC +125ºC +20ºC
IL* 10 x IL* 12.5xIL* IL*
±5% +20/-0% +30/-0% ±5%
IL* 1.5 x IL* 2xIL* IL*
Test temperature: 125ºC+3/0ºC
Test voltage: Category voltage at 125ºC
Surge voltage: 1.3 x category voltage at 125ºC
Series protection resistance 1000±100Ω
Discharge resistance: 1000Ω
Number of cycles: 1000x
Cycle duration: 6 min; 30 sec charge,
5 min 30 sec discharge
Visual examination
DCL
ΔC/C
DF
no visible damage
initial limit
within +20/-30% of initial value
1.25 x initial limit
*Initial Limit
OCTOBER 2013 n 75