 English |
|
|
|
|
|
|
|
| ASSR-1510 Datasheet, PDF (9/15 Pages) AVAGO TECHNOLOGIES LIMITED – Compact Solid-State Bi-directional Signal Switch | |||
| |||
| ◁ |
Electrical Specifications (DC)
Over recommended operating TA = -40°C to 85°C, IF = 5mA to 10mA, unless otherwise specified.
Parameter
Output Withstand
Voltage
Sym.
|VO(OFF)|
Output Leakage
Current
IO(OFF)
Output Offset
Voltage
Input Reverse
Breakdown Volt-
age
Input Forward
Voltage
Output
On-resistance
|V(OS)|
VR
VF
R(ON)
ASSR-1511
Connection B
R(ON)
Min. Typ.
60
65
55
0.5
1
5
Max. Units Conditions
Fig. Note
V
VF =0.8V, IO=250 ïA, TA=25ï°C
V
VF =0.8V, IO=250 ïA
5
100 nA
VF =0.8V, VO=60V, TA=25ï°C
1
ïA
VF =0.8V, VO=60V
6
ïV
IF =5mA, IO=0mA
V
IR =10 ïA
1.1 1.3
1.65 V
0.35 0.5 ï
0.12 0.2 ï
IF =5mA
IF =5mA, IO=1A,
Pulse ï£30ms, TA=25ï°C
IF =5mA, IO=2A,
Pulse ï£30ms, TA=25ï°C
8, 9
10, 11 6
Switching Specifications (AC)
Over recommended operating TA = -40°C to 85°C, IF = 5mA to 10mA, unless otherwise specified.
Parameter
Turn On Time
Turn Off Time
Output Transient
Rejection
Input-Output
Transient Rejection
Sym. Min. Typ. Max. Units Conditions
TON
0.5
1.0
ms
IF =5mA, IO=1A, TA=25ï°C
2.0
ms
IF =5mA, IO=1A
0.25 0.5
ms
IF =10mA, IO=1A, TA=25ï°C
1.0
ms
IF =10mA, IO=1A
TOFF
0.03 0.2
ms
IF =5mA, IO=1A, TA=25ï°C
0.5
ms
IF =5mA, IO=1A
0.02 0.15 ms
IF =10mA, IO=1A, TA=25ï°C
0.2
ms
IF =10mA, IO=1A
dVO/dt 1
7
kV/ïs ïVO=60V, TA=25ï°C
dVI-O/dt 1
ï³ï 10
kV/ïs ïVI-O=1000V, TA=25ï°C
Fig. Note
12, 16
13
14, 16
15
17
18
Notes:
1. For derating, refer to Figure 1, 2, 3 and 4.
2. The voltage across the output terminals of the relay should not exceed this rated withstand voltage. Over-voltage protection circuits should
be added in some applications to protect against over-voltage transients.
3. Threshold to switch device is IF ï³ 0.5mA, however, for qualified device performance over temperature range, it is recommended to operate at
IF =5mA.
4. Device is considered as a two terminal device:
ASSR-1510 - pin 1, 2 shorted and pin 3, 4 shorted.
ASSR-1511 - pin 1, 2, 3 shorted and pin 4, 5, 6 shorted.
ASSR-1520 and ASSR-1530 - pin 1, 2, 3, 4 shorted and pin 5, 6, 7, 8 shorted.
5. The Input-Output Momentary Withstand Voltage is a dielectric voltage rating that should not be interpreted as an input-output continuous
voltage rating. For the continuous voltage rating refer to the IEC/EN/DIN EN 60747-5-2 Insulation Characteristics Table (if applicable), your
equipment level safety specification, or Avago Technologies Application Note 1074, âOptocoupler Input-Output Endurance Voltage.â
6. During the pulsed R(ON) measurement ( IO duration ï£30ms), ambient (TA) and case temperature (TC) are equal.
9
|
▷ |
German
Russian
Spanish
Italian
Polish
Chinese
Japanese
Korean
French
Portuguese