AFBR-5701Z Datasheet, PDF (6/22 Pages) AVAGO TECHNOLOGIES LIMITED – SFP OPtical Transceivers with Optional DMI for Gigabit Ethernet

Fiber Compatibility
The AFBR-570xZ transciever is capable of transmission
at 2 to 550 meters with 50/125 µm fiber, and at 2 to
275 meters with 62.5 125 µm fiber, for 1.25 GBd
Ethernet. It is capable of transmission up to 500m with
50/125 µm fiber and up to 300m with 62.5/125 µm
fiber, for 1.0625 GBd Fiber Channel.
Application Support
To assist in the transceiver evaluation process, Agilent
offers a 1.25 Gbd Gigabit Ethernet evaluation board
which facilitates testing of the AFBR-570xZ. It can be
obtained through the Agilent Field Organization by
referencing Agilent part number HFBR-0571.
A Reference Design including the AFBR-570xZ and the
HDMP-1687 GigaBit Quad SerDes is available. It may
be obtained through the Agilent Field Sales
organization.
Regulatory Compliance
See Table 1 for transceiver Regulatory Compliance.
Certification level is dependent on the overall
configuration of the host equipment. The transceiver
performance is offered as a figure of merit to assist the
designer.
Electrostatic Discharge (ESD)
The AFBR-570xZ exceeds typical industry standards
and is compatible with ESD levels found in typical
manufacturing and operating environments as
described in Table 1.
There are two design cases in which immunity to ESD
damage is important.
The first case is during handling of the transceiver prior
to insertion into the transceiver port. To protect the
transceiver, it’s important to use normal ESD handling
precautions. These precautions include using grounded
wrist straps, work benches, and floor mats in ESD
controlled areas. The ESD sensitivity of the AFBR-570xZ
is compatible with typical industry production
environments.
The second case to consider is static discharges to the
exterior of the host equipment chassis after installation.
To the extent that the optical interface is exposed to
the outside of the host equipment chassis, it may be
subject to system-level ESD requirements.
Electromagnetic Interference (EMI)
Equipment using the AFBR-570xZ family of transceivers
is typically required to meet the requirements of the
FCC in the United States, CENELEC EN55022 (CISPR 22)
in Europe, and VCCI in Japan.
The metal housing and shielded design of the AFBR-
570xZ minimize the EMI challenge facing the host
equipment designer.
EMI Immunity
Equipment hosting AFBR-570xZ modules will be
subjected to radio-frequency electromagnetic fields in
some environments. The transceiver has excellent
immunity to such fields due to its shielded design.
Flammability
The AFBR-570xZ transceiver is made of metal and high
strength, heat resistant, chemically resistant, and UL
94V-0 flame retardant plastic.
Customer Manufacturing Processes
This module is pluggable and is not designed for
aqueous wash, IR reflow, or wave soldering processes.
6