HDSP-S8XE Datasheet, PDF (5/8 Pages) AVAGO TECHNOLOGIES LIMITED – 17.5 mm (0.69 inch) General Purpose 8 x 8 Dot Matrix Alphanumeric Displays

Absolute Maximum Ratings at T_A = 25˚C
Parameter
Average Power per Dot^[1]
Peak Forward Current per Dot^[1]
(1/8 Duty Cycle at 10 KHz)
Average Forward Current per Dot
GaP Red
HDSP-S80E/S85E
65
80
25^[1,2]
GaP Green
HDSP-S80G/S85G
65
100
25^[1,3]
Units
mW
mA
mA
Reverse Voltage per Dot
Operating Temperature
Storage Temperature
Wave Soldering Temperature for 3 seconds^[4]
(2 mm [0.078 in.] below Body)
3
–35 to +85
–35 to +85
250
3
V
–35 to +85
°C
–35 to +85
°C
250
°C
Notes:
1. Do not exceed maximum average current per dot.
2. Derate above 25°C at 0.20 mA/°C.
3. Derate above 25°C at 0.33 mA/°C.
4. Not recommended to be soldered more than 2 times. Minimum interval between solderings is 15 minutes. Total soldering time not to exceed 3 seconds.
Optical/Electrical Characteristics at T_A = 25˚C
GaP Red
Devices
HDSP- Parameter
Luminous Intensity/Dot
(Digit Average)^[1]
Peak Wavelength
S80E/
S85E
Dominant Wavelength^[2]
Forward Voltage
Reverse Voltage^[3]
Luminous Intensity
Matching Ratio
Symbol
I_v
λ_peak
λ_d
V_F
V_R
I_v-m
Min. Typ.
0.82 1.2
632
622
2.1
3.0
Max.
2.4
2:1
Units
mcd
nm
nm
V
V
Test Conditions
I_FP = 40 mA,
1/8 Duty Factor
I_F = 20 mA
I_F = 20 mA
I_F = 20 mA
I_R = 100 µA
I_FP = 40 mA,
1/8 Duty Factor
GaP Green
Devices
HDSP- Parameter
Luminous Intensity/Dot
(Digit Average)^[1]
Peak Wavelength
S80G\
S85G
Dominant Wavelength^[2]
Forward Voltage
Reverse Voltage^[3]
Luminous Intensity
Matching Ratio
Symbol
I_v
λ_peak
λ_d
V_F
V_R
I_v-m
Min. Typ.
1.0
1.5
568
573
2.3
3.0
Max.
2.6
2:1
Units
mcd
nm
nm
V
V
Test Conditions
I_FP = 40 mA,
1/8 Duty Factor
I_F = 20 mA
I_F = 20 mA
I_F = 20 mA
I_R = 100 µA
I_FP = 40 mA,
1/8 Duty Factor
Notes:
1. The digits are categorized for luminous intensity. The intensity category is designated by a letter on the side of the package.
2. The dominant wavelength, λ_d, is derived from the CIE chromaticity diagram and represents the single wavelength which defines the color of the device.
3. Typical specification for reference only. Do not exceed absolute maximum ratings.
5