HFBR-4501 Datasheet, PDF (4/10 Pages) AVAGO TECHNOLOGIES LIMITED – Plastic Optical Fiber Cable and Accessories for Versatile Link

Plastic Optical Fiber Connector Absolute Maximum Ratings
Parameter
Symbol
Min.
Max.
Unit
Note
Storage and Operating Temperature
Recommended Operating Temperature
Installation Temperature
Nut Torque
HFBR-4505/4515 Adapter
T_S,O
-40
85
°C
1
T_O
-40
85
°C
1
T_l
0
70
°C
1
T_N
0.7
N-m
2
100
OzF-in.
Notes:
1. Storage and Operating Temperatures refer to the ranges over which the connectors can be used when not subjected to mechanical stress.
Installation Temperature refers to the ranges over which connectors may be installed onto the fiber and over which connectors can be con-
nected and disconnected from transmitter and receiver modules.
2. Recommended nut torque is 0.57 N-m.
Plastic Optical Fiber Connector Mechanical/Optical Characteristics
T_A = -40 to +85°C, Unless Otherwise Specified.
Parameter   Part Number
Symbol Min. Typ.^[1] Max. Units Temp. °C Note
Retention Force,
Connector to
Simplex,
HFBR-4501/4511
F_R-C
7
8
3
N
+25
2
-40 to +85
Versatile Link Transmit-
ters and Receivers
Simplex Latching,
HFBR-4503/4513
47
80
11
+25
-40 to +85
Duplex,
HFBR-4506
7
12
4
+25
-40 to +85
Duplex Latching,
HFBR-4516
50
80
15
+25
-40 to +85
Tensile Force,
Simplex,
F_T
8.5 22
N
3
Connector to Cable
HFBR-4501/4511
Simplex Latching,
HFBR-4503/4513
8.5 22
Duplex, HFBR-4506
14
35
Duplex Latching,
HFBR-4516
14
35
Adapter Connector
to Connector Loss
HFBR-4505/4515 with
HFBR-4501/4511
α_CC
0.7 1.5
2.8 dB
25
4, 5
Retention Force
HFBR-4505/4515 with
F_R-B
7
8
N
Connector to Adapter
HFBR-4501/4511
Insertion Force,
Simplex,
F_I
8
30
N
6
Connector to Versatile
HFBR-4501/4511
Link Transmitters and
Receivers
Simplex Latching,
HFBR-4503/4513
16
35
Duplex, HFBR-4506
13
46
Duplex Latching
HFBR-4516
22
51
Notes:
1. Typical data are at +25°C.
2. No perceivable reduction in retention force was observed after 2000 insertions. Retention force of non-latching connectors is lower at elevated
temperatures. Latching connectors are recommended for applications where a high retention force at high temperatures is desired.
3. For applications where frequent temperature cycling over temperature extremes is expected, please contact Avago Technologies for alternate
connectoring techniques.
4. Minimum and maximum limit for α_CC for 0°C to +70°C temperature range. Typical value of α_CC is at +25°C.
5. Factory polish or field polish per recommended procedure.
6. Destructive insertion force was typically at 178 N (40 lb.).