SFH756_07 Datasheet, PDF (2/6 Pages) AVAGO TECHNOLOGIES LIMITED – Plastic Fiber Optic Transmitter Diode Plastic Connector Housing

Technical Data
Absolute Maximum Ratings
Parameter
Operating Temperature Range
Storage Temperature Range
Junction Temperature
Soldering Temperature(2?mm from case bottom, t ≤ 5 s)
Reverse Voltage
Forward Current
Surge Current (t ≤ 10 μs, D = 0)
Power Dissipation
Thermal Resistance, Junction/Air
Limit Values
Symbol
min.
max.
Unit
T_OP
–40
T_STG
–40
T_J
TS
+85
°C
+100
°C
100
°C
260
°C
VR
3
V
I_F
50
mA
I_FSM
1
A
P_TOT
120
mW
R_thJA
450
K/W
Characteristics (T_A = 25°C)
Parameter
Symbol
Value
Unit
Peak Wavelength
λ_Peak
660
nm
Spectral Bandwidth
Switching Times (R_G = 50 Ω, I_F(LOW) = 0.1mA, I_F(HIGH) = 50 mA)
10% to 90%
90% to 10%
Δ_λ
25
nm
μs
t_R
0.1
t_F
0.1
Capacitance (f = 1 MHz, V_R = 0 V)
Forward Voltage (I_F = 50 mA)
Output Power Coupled Into Plastic Fiber
(I_F = 10 mA) ^[1]
Temperature Coefficient Φ_IN
C_O
30
pF
V_F
2.1 (≤ 2.8) V
Φ_IN
200
μW
(≥ 100)
T_CΦ
–0.4
%/K
Temperature Coefficient V_F
T_CV
–3
mV/K
Temperature Coefficient λ_Peak
TC_λ
0.16
nm/K
Notes:
1. The output power coupled into plastic fiber is measured with a large area detector after a short fiber (about 30 cm). This value must not used for
calculating the power budget for a fiber optic system with a long fiber because the numerical aperture of plastics fibers is decreasing on the first
meters. Therefore the fiber seems to have compared with the specified value a higher attenuation on the first meters.