ODIN-MIT4-02 Datasheet, PDF (2/7 Pages) AVAGO TECHNOLOGIES LIMITED – TTL Data Input (Logic to Light Function)

Table 1. Absolute Maximum Ratings
Limit Values
Parameter
Symbol min. max Unit.
Supply Voltage
V_CCMax
-0.5
6.0
V
Storage Temperature Range
T_STG
Soldering Temperature (>2.5 mm from case bottom t ≤ 10s)
T_S
-40
100
°C
–
260
°C
Voltage at any PIN
Electrostatic Discharge Voltage Capability^[1]
-0.5
V_CC +0.5 V
ESD
–
2.0
kV
Notes:
1. ESD Capability for all Pins HBM (human body model) according JESD22-A114B.
Table 2. Recommended Operating Conditions
Limit Values
Parameter
Symbol min. max. Unit
Supply Voltage low
V_{CC_l}
3.135 3.465 V
Supply Voltage high
V_{CC_h}
4.75
5.25
V
Operating Temperature Range (ambient)^[1]
T_A
-40
95
°C
Notes:
1. For details see application note “Handling, Storage, Operating and Processing Application Note of ODIN MOST4 Transceiver”
All the data in this specification refers to the operating conditions above and over life time unless otherwise stated.
Table 3. DC Characteristics
Limit Values
Parameter
Symbol min. typ. max. Unit
Low Level Input Voltage
V_IL
-0.3
–
0.8
V
High Level Input Voltage
V_IH
Input Leakage Current(V_CC = 5.0 V, V_I = 0.0 V or V_I = 5.0 V)
I_L
2.0
–
V_CC + 0.3 V
–
–
± 20 µA
Input Capacitance
C_I
–
–
7
pF
Input Resistance
R_I
2
–
–
kΩ
Supply Current (R_ext = 15 kΩ) ON state, biphase coded data^[1] I_CC
–
–
35
mA
Supply Current (R_ext = 15 kΩ) OFF state^[2]
I_LP2
–
–
20
µA
Notes:
1. The current through the LED and therefore the optical output power and overall power consumption depends on the settings of R_ext. The
nominal value for R_ext is 15 kΩ. With R_ext = 30 kΩ the optical output power is about -3 dB of the nominal value. Typical behavior see Figure 1.
Important: The external resistor of R_ext must be within the range of 13.5 kΩ to 33 kΩ. For values of R_ext out of this range functionality
may not be given over the whole temperature range and the device lifetime. Using values below 13 kΩ for R_ext can damage the
transmitter.
2. If the transmitter is in full power mode it is switched OFF 1 ms (max.) after TX DATA is low. If the transmitter is in low power mode it is switched
ON 6 ms (max.) after TX DATA transmission starts.
Attention
Stresses above those listed here may cause permanent damage to the device. Exposure to absolute maximum
rating conditions for extended periods may affect device reliability. Between 3.465V and 4.75V the device is not
specified according Table2. Therefore operation is limited to the range of 3.135V ... 3.465V or 4.75V ... 5.25V.