ASMT-YTB2-0BB02 Datasheet, PDF (12/15 Pages) AVAGO TECHNOLOGIES LIMITED – High Brightness Tricolor PLCC6 Black Surface LED

ASMT-YTB2-0BB02
Data Sheet
Soldering
Recommended reflow soldering condition:
(i) Leaded reflow soldering
20 SEC. MAX.
240°C MAX.
3°C/SEC. MAX.
100-150°C
183°C
3°C/SEC.
MAX.
120 SEC. MAX. 60-150 SEC.
TIME
-6°C/SEC.
MAX.
Soldering
(ii) Lead-free reflow soldering
217°C
200°C
150°C
255 - 260 °C
3°C/SEC. MAX.
3 °C/SEC. MAX.
60 - 120 SEC.
TIME
10 to 30 SEC.
6°C/SEC. MAX.
100 SEC. MAX.
1. Reflow soldering must not be done more than 2 times.
Make sure the necessary precautions are observed for
handling moisture-sensitive device as stated in the
following section.
2. Recommended board reflow direction:
3. Do not apply any pressure or force on the LED during
reflow and after reflow when the LED is still hot.
4. It is preferred to use reflow soldering to solder the LED. Use
hand soldering for rework if this is unavoidable, but it must
be strictly controlled to the following conditions:
— Soldering iron tip temperature = 320 °C max
— Soldering duration = 3 sec max
— Number of cycles = 1 only
— Power of soldering iron = 50 W max
5. Do not touch the LED body with hot soldering iron except
the soldering terminals as it may cause damage to the LED.
6. For de-soldering, it is recommended that you use a double
flat tip.
7. You are advised to confirm beforehand whether hand
soldering will affect the functionality and performance of
the LED.
REFLOW DIRECTION
Avago Technologies
- 12 -