ASMB-MTB1-0A3A2 Datasheet, PDF (11/13 Pages) AVAGO TECHNOLOGIES LIMITED – PLCC-4 Tricolor Black Surface LED

Soldering
Recommended reflow soldering condition:
(i) Leaded reflow soldering:
(ii) Lead-free reflow soldering:
20 SEC. MAX.
240°C MAX.
3°C/SEC. MAX.
100-150°C
183°C
3°C/SEC.
MAX.
120 SEC. MAX. 60-150 SEC.
TIME
-6°C/SEC.
MAX.
217°C
200°C
150°C
255 - 260 °C
3°C/SEC. MAX.
3 °C/SEC. MAX.
60 - 120 SEC.
TIME
10 to 30 SEC.
6°C/SEC. MAX.
100 SEC. MAX.
a. Reflow soldering must not be done more than two
times. Make sure you take the necessary precautions
for handling a moisture-sensitive device, as stated in
the following section.
b. Recommended board reflow direction:
c. Do not apply any pressure or force on the LED during
reflow and after reflow when the LED is still hot.
d. It is preferred that you use reflow soldering to
solder the LED. Use hand soldering only for rework
if unavoidable but must be strictly controlled to the
following conditions:
- Soldering iron tip temperature = 320 °C max.
- Soldering duration = 3 sec max.
- Number of cycles = 1 only
- Power of soldering iron = 50 W max.
e. Do not touch the LED body with a hot soldering iron
except the soldering terminals as this may damage the
LED.
f. For de-soldering, it is recommended that you use a
double flat tip.
g. Please confirm beforehand whether the functionality
and performance of the LED is affected by hand
soldering.
REFLOW DIRECTION
11