ASSR-1218 Datasheet, PDF (10/12 Pages) AVAGO TECHNOLOGIES LIMITED – Compact Solid-State Bi-directional Signal Switch

Switching Specifications (AC)
For operating T_A = +25°C
Parameter
Sym.
Min. Typ.
Max. Units Conditions
Fig.
Note
Turn On Time
T_ON
0.7
5.0
ms
I_F =5mA, I_O=200mA
Turn Off Time
T_OFF
0.04
5.0
ms
I_F =5mA, I_O=200mA,
Notes:
1. For derating, refer to Figure 1, 2, 3 and 4.
2. The voltage across the output terminals of the relay should not exceed this rated withstand voltage. Over-voltage protection circuits should
be added in some applications to protect against over-voltage transients.
3. Threshold to switch device is I_F ≥ 0.5mA, however, for qualified device performance over temperature range, it is recommended to operate at
I_F =5mA.
4. Device is considered as a two terminal device:
ASSR-1218 - pin 1, 2 shorted and pin 3, 4 shorted.
ASSR-1219 - pin 1, 2, 3 shorted and pin 4, 5, 6 shorted.
ASSR-1228 - pin 1, 2, 3, 4 shorted and pin 5, 6, 7, 8 shorted.
5. The Input-Output Momentary Withstand Voltage is a dielectric voltage rating that should not be interpreted as an input-output continuous
voltage rating. For the continuous voltage rating refer to the IEC/EN/DIN EN 60747-5-2 Insulation Characteristics Table (if applicable), your
equipment level safety specification, or Avago Technologies Application Note 1074, “Optocoupler Input-Output Endurance Voltage.”
6. During the pulsed R_(ON) measurement ( I_O duration ≤30ms), ambient (T_A) and case temperature (T_C) are equal.
10