English
Language : 

SFH250_11 Datasheet, PDF (1/4 Pages) AVAGO TECHNOLOGIES LIMITED – Receiver with analog output for polymer optical fiber applications
SFH250 and SFH250V
Receiver with analog output
for polymer optical fiber applications
Data Sheet
Description
The SFH250 is a low-cost 650nm receiver for optical
data transmission with polymer optical fiber. This Si-
pin-photodiode works fine with the AVAGO transmitter
SFH757. According to the intensity of the incident light
the SFH250 generates an analog photocurrent. In typical
applications the SFH250 is operated in reverse-biasing
and is installed in series with a resistor, where the voltage
tapping is taken. By increasing the reverse voltage the
switching times decrease and the SFH250 can be used for
transmission speeds up to 100MBd.
Components of the SFH series are optimized for easy
coupling. No fiber stripping is required, only the cut fiber
has to be inserted into the selected SFH component.
SFH250
The transparent plastic package has an aperture where a
2.2mm fiber end can be inserted. This very easy coupling
method is extremely cost-effective.
SFH250V
The V-housing allows easy coupling of unconnectorized
2.2mm polymer optical fiber by means of an axial locking
screw.
Ordering Information
Features
• Fast Switching Time
• Sensitive in visible and near IR Range
• High linearity
• 2.2mm aperture holds standard 980/1000/2200 um
plastic fiber
• No fiber stripping required
• Molded microlens for efficient coupling
Plastic Direct Fiber Connector housing
(V-housing)
• Locking screw attached to the connector
• Interference-free transmission by the light-tight
housing
• Transmitter and receiver can be positioned flexibly
• No cross talk
• Auto insertable and wave solderable
• Supplied in tubes
Applications
• Household electronics
• Power electronics
• Optical networks
• Light barriers
SFH250
Type
SFH250
SFH250V
SFH250V
Ordering Code
SP000063866
SP000063852
Application Literature
AN #
5342
5341
Description
General information about the SFH series
with Selection Guide and recommendations
regarding System Planning and Mounting
Information about Basic and Special Circuits for
Transmitter and Receiver of the SFH series