HFCT-711XPD Datasheet, PDF (1/14 Pages) AVAGO TECHNOLOGIES LIMITED – Multi-rate 1310 nm XFP 10 Gbit/s Optical Transceiver

HFCT-711XPD
Multi-rate 1310 nm XFP 10 Gbit/s Optical Transceiver
Data Sheet
Description
The 1310 nm XFP transceiver is a high performance, cost
effective module for serial optical data communications
applications specified for signal rates of 9.95 Gb/s to 10.5
Gb/s. It is compliant to XFP MSA Rev 4.5. The module is
designed for single mode fiber and operates at a nominal
wavelength of 1310 nm. The transmitter section
incorporates a directly modulated 1310 nm distributed
feedback laser (DFB). The receiver section uses an MOVPE
grown planar SEDET PIN photodetector for low dark
current and excellent responsivity. Integrated Tx and Rx
eye openers provide high jitter-tolerance and low jitter-
generation and transfer for full XFI and SONET
compliance. The internally ac coupled high speed serial
I/O simplifies interfacing to external circuitry. The
electrical interface is made using an industry standard
0.8 mm pitch 30-pin right angle connector. Optical
connection is made via the duplex LC connector.
Features
• Compliant to XFP MSA
• Multi-protocol multi-bitrate compliant
- Compliant to SONET/SDH OC-192/STM-64 rate 9.9532
Gb/s, Telcordia GR-253-CORE SR-1, ITU-T G.691 I64.1
- Compliant to IEEE 802.3ae 10GBASE-LR for 10GbE,
10.3125 Gb/s
- Compliant to 10GFC 1310 nm Serial PMD, type 1200-
SM-LL-L, 10.51875 Gb/s
- Compatible with 10.7Gb/s and 11.3Gb/s operation for
FEC functionality
• Uncooled 1310 nm DFB Laser and PIN Photodiode
• Compliant XFI 10G Serial electrical interface
• LC Duplex optical connector interface conforming to
ANSI TIA/EIA604-10 (FOCIS 10)
• 1.5W typical power dissipation
• Superior Thermal and EMI performance to support high
port densities
• Customizable clip-on heatsink to support a variety of line
card environments
• -5 to +70 °C case operating temperature range
• Capable of extended temperature (-10°C to +85°C, Case
temperature) operation**
• Hardware pins are available for the following control
signals:
- Transmitter disable
- Module power down/reset
- Receiver loss of signal
- Module not ready
- programmable interrupt
• 2-wire serial management interface provides real time
monitors of:
- Transmitted Optical Power
- Received Optical Power
- Laser Bias Current
- Module Temperature
- Supply Voltage
- Laser Temperature
• Link Lengths up to 10 km with 9 µm SMF
• IEC 60825-1 Class 1/CDRH Class 1 laser eye safe
Note:
** Long term reliability at elevated temperatures is not guaranteed”
Applications
• Fiber Channel Switches
• Host Bus Adapter Cards
• Mass Storage System and Server I/O
• Optical Cross Connect Switches
· Next generation SONET/SDH ADMs
· Core Routers