|
HCPL-0300-500E Datasheet, PDF (1/14 Pages) AVAGO TECHNOLOGIES LIMITED – 8 MBd Low Input Current Optocoupler | |||
|
HCPL-2300, HCPL-0300
8 MBd Low Input Current Optocoupler
Data Sheet
Lead (Pb) Free
RoHS 6 fully
compliant
RoHS 6 fully compliant options available;
-xxxE denotes a lead-free product
Description
The HCPL-2300/HCPL-0300 optocoupler combines
an 820 nm AlGaAs photon emitting diode with an
integrated high gain photon detector. This combina-tion
of Avago designed and manufactured semiconductor
devices brings new high performance capabilities to
designers of isolated logic and data communication cir-
cuits.
The new low current, high speed AlGaAs emitter manu-
factured with a unique diffused junction, has the virtue
of fast rise and fall times at low drive currents. Figure 6 il-
lustrates the propagaÂtion delay vs. input current charac-
teristic. These unique characteristics enable this device
to be used in an RS-232-C interÂface with ground loop iso-
lation and improved common mode rejection. As a line
receiver, the HCPL-2300/HCPL-0300 will operate over
longer line lengths for a given data rate because of lower
IF and VF specifications.
Functional Diagram
NC 1
8 VCC
ANODE 2
7 RL
CATHODE 3
6 VOUT
Features
⢠Guaranteed low thresholds: IF = 0.5 mA, VF ⤠1.5 V
⢠High speed: guaranteed 5âMBd over temperature
⢠Versatile: compatible with TTL, LSTTL and CMOS
⢠Efficient 820 nm AlGaAs LED
⢠Internal shield for guaranteed common mode
rejection
⢠Schottky clamped, open collector output with
optional integrated pull-up resistor
⢠Static and dynamic performance guaranteed from
-40°C to 85°C
⢠Safety approval
â UL recognized -3750 V rms for 1 minute
â CSA approved
â IEC/EN/DIN EN60747-5-5 approved with
VIORMâ=â630 V peak (Option 060)
Applications
⢠Ground loop elimination
⢠Computer-peripheral interfaces
⢠Level shifting
⢠Microprocessor system interfaces
⢠Digital isolation for A/D, D/A conversion
⢠RS-232-C interface
⢠High speed, long distance isolated line receiver
NC 4
5 GND
A 0.1 pF bypass capacitor must be connected between pins 5 and 8.
CAUTION: It is advised that normal static precautions be taken in handling and assembly
of this component to prevent damage and/or degradation which may be induced by ESD.
|
▷ |