ASSR-3211 Datasheet, PDF (1/14 Pages) AVAGO TECHNOLOGIES LIMITED – General Purpose, Form A, Solid State Relay (Photo MOSFET)

ASSR-3210, ASSR-3211, ASSR-3220
General Purpose, Form A, Solid State Relay (Photo MOSFET)
(250V/0.2A/10)
Data Sheet
Lead (Pb) Free
RoHS 6 fully
compliant
RoHS 6 fully compliant options available;
-xxxE denotes a lead-free product
Description
The ASSR-32XX Series consists of an AlGaAs infrared
light-emitting diode (LED) input stage optically coupled
to a high-voltage output detector circuit. The detector
consists of a high-speed photovoltaic diode array and
driver circuitry to switch on/off two discrete high volt-
age MOSFETs. The relay turns on (contact closes) with a
minimum input current of 3mA through the input LED.
The relay turns off (contact opens) with an input voltage
of 0.8V or less.
The single channel configurations, ASSR-3210 and ASSR-
3211, are equivalent to 1 Form A Electromechanical
Relays (EMR), and the dual channel configuration, ASSR-
3220, is equivalent to 2 Form A EMR. They are available
in 4-pin SO, 6-pin DIP, 8-pin DIP and Gull Wing Surface
Mount for DIP packages. Their electrical and switching
characteristics are specified over the temperature range
of -40°C to +85°C. They are used for general purpose
switching of signals and low power AC/DC loads.
ASSR-3211 enables AC/DC and DC-only output connec-
tions. For DC-only connection, the output current, Io,
increases to 0.4A and the on-resistance, R_(ON) reduces
to 2.5.
Applications
 Telecommunication Switching
 Data Communications
 Industrial Controls
 Medical
 Security
 EMR / Reed Relay Replacement
Features
 Compact Solid-State Bi-directional Signal Switch
 Single and Dual Channel Normally-off Single-Pole-
Single-Throw (SPST) Relay
 250V Output Withstand Voltage
 0.2A or 0.4A Current Rating
(See Schematic for ASSR-3211 Connections A & B)
 Low Input Current:
CMOS Compatibility
 Low On-Resistance:
2 Typical for DC-only, 8 Typical for AC/DC
 Very High Output Off-state Impedance:
10 Teraohms Typical
 High Speed Switching:
0.25ms (Ton), 0.02ms (Toff ) Typical
 High Transient Immunity: >1kV/s
 High Input-to-Output Insulation Voltage
(Safety and Regulatory Approvals)
- 3750 Vrms for 1 min per UL1577
- CSA Component Acceptance
Functional Diagram
Opto-isolation
1
4 _{Truth Table}
LED Output
Off Open
On Close
2
3
Single Channel, SPST Relay,
1 Form A in 4-Pin SO Package
CAUTION: It is advised that normal static precautions be taken in handling and assembly
of this component to prevent damage and/or degradation which may be induced by ESD.