AMMC-6220 Datasheet, PDF (1/8 Pages) AVAGO TECHNOLOGIES LIMITED – 6 - 20 GHz Low Noise Amplifier

AMMC - 6220
6 - 20 GHz Low Noise Amplifier
Data Sheet
Chip Size: 1700 x 800 µm (67 x 31.5 mils)
Chip Size Tolerance: ± 10 µm (±0.4 mils)
Chip Thickness: 100 ± 10 µm (4 ± 0.4 mils)
Pad Dimensions: 100 x 100 µm (4 ± 0.4 mils)
Description
Avago Technologies’ AMMC-6220 is a high gain, low-
noiseamplifier that operates from 6 GHz to 20 GHz. This
LNA provides a wide-band solution for system design
since it covers several bands, thus, reduces part inven-
tory. The device has input / output match to 50 Ohm, is
unconditionally stable and can be used as either primary
or sub-sequential low noise gain stage. By eliminating
the complex tuning and assembly processes typically
required by hybrid (discrete-FET) amplifiers, the AMMC-
6220 is a cost-effective alternative in the 6 - 20 GHz com-
munications receivers. The backside of the chip is both RF
and DC ground. This helps simplify the assembly process
and reduces assembly related performance variations
and costs. It is fabricated in a PHEMT process to provide
exceptional noise and gain performance. For improved
reliability and moisture protection, the die is passivated
at the active areas.
Features
• Wide frequency range: 6 - 20 GHz
• High gain: 23 dB
• Low 50 Ω Noise Figure: 2.0 dB
• 50 Ω Input and Output Match
• Single 3V Supply Bias
Applications
• Microwave Radio systems
• Satellite VSAT, DBS Up/Down Link
• LMDS & Pt-Pt mmW Long Haul
• Broadband Wireless Access
(including 802.16 and 802.20 WiMax)
• WLL and MMDS loops
AMMC-6220 Absolute Maximum Ratings^[1]
Symbol
V_d
V_g
I_d
P_in
T_ch
T_stg
T_max
Parameters/Conditions
Positive Drain Voltage
Gate Supply Voltage
Drain Current
CW Input Power
Operating Channel Temp.
Storage Case Temp.
Maximum Assembly Temp (60 sec max)
Units
Min.
V
V
mA
dBm
°C
°C
-65
°C
Note:
1. Operation in excess of any one of these conditions may result in permanent damage to this device
Max.
7
NA
100
15
+150
+150
+300
Note: These devices are ESD sensitive. The following precautions are strongly recommended. Ensure
that an ESD approved carrier is used when dice are transported from one destination to another.
Personal grounding is to be worn at all times when handling these devices