AFBR-5803Z Datasheet, PDF (1/16 Pages) Agilent(Hewlett-Packard) – FDDI, 100 Mb/s ATM, and Fast Ethernet Transceivers in Low Cost 1 x 9 Package Style

AFBR-5803Z/5803TZ/5803AZ/5803ATZ
FDDI, 100 Mb/s ATM, and Fast Ethernet Transceivers
in Low Cost 1 x 9 Package Style
Data Sheet
Description
The AFBR-5800Z family of trans­ceivers from Avago Tech-
nologies provide the system designer with products
to implement a range of Fast Ethernet, FDDI and ATM
(Asynchronous Transfer Mode) designs at the 100 Mb/s-
125 MBd rate.
The transceivers are all supplied in the industry standard
1 x 9 SIP package style with either a duplex SC or a duplex
ST* connector interface.
FDDI PMD, ATM and Fast Ethernet 2 km Backbone Links
The AFBR-5803Z/5803TZ are 1300 nm products with
optical performance compliant with the FDDI PMD
standard. The FDDI PMD standard is ISO/IEC 9314‑3:
1990 and ANSI X3.166 - 1990.
These transceivers for 2 km multimode fiber backbones
are supplied in the small 1 x 9 duplex SC or ST package
style.
The AFBR-5803Z/5803TZ is useful for both ATM 100 Mb/s
interfaces and Fast Ethernet 100 Base-FX interfaces.
The ATM Forum User-Network Interface (UNI) Standard,
Version 3.0, defines the Physical Layer for 100 Mb/s
Multimode Fiber Interface for ATM in Section 2.3 to be
the FDDI PMD Standard. Likewise, the Fast Ethernet
Alliance defines the Physical Layer for 100 Base-FX for
Fast Ethernet to be the FDDI PMD Standard.
ATM applications for physical layers other than 100 Mb/s
Multimode Fiber Interface are supported by Avago Tech-
nologies. Products are available for both the single mode
and the multi­mode fiber SONET OC-3c (STS‑3c) ATM in-
terfaces and the 155 Mb/s-194 MBd multi­mode fiber ATM
interface as specified in the ATM Forum UNI.
Contact your Avago Technologies sales representative
for infor­ma­tion on these alternative Fast Ethernet, FDDI
and ATM products.
Features
• Full compliance with the optical performance
requirements of the FDDI PMD standard
• Full compliance with the FDDI LCF-PMD standard
• Full compliance with the optical performance
requirements of the ATM 100 Mb/s physical layer
• Full compliance with the optical performance
requirements of 100 Base‑FX version of IEEE 802.3u
• Multisourced 1 x 9 package style with choice of duplex
SC or duplex ST* receptacle
• Wave solder and aqueous wash process compatible
• Single +3.3 V or +5 V power supply
• RoHS Compliance
Applications
• Multimode fiber backbone links
• Multimode fiber wiring closet to desktop links
• Very low cost multimode fiber links from wiring closet
to desktop
• Multimode fiber media converters
*ST is a registered trademark of AT&T Lightguide Cable Connectors.