AFBR-0548Z Datasheet, PDF (1/2 Pages) AVAGO TECHNOLOGIES LIMITED – Connect 0V to GND pin of 3 pin connector

AFBR-0548Z Evaluation Kit
DC to 50MBd 650nm Versatile Link
Fiber Optic Miniature Evaluation Kit
User Guide
Introduction
AFBR-0548Z is used to evaluate Avago fiber optics device
AFBR-1624Z and AFBR-2624Z.
The evaluation kit is equipped with necessary documents
and accessories to ease production and verification.
Evaluation Kit
AFBR-0548Z contains
1. Evaluation board
2. AFBR-1624Z and AFBR-2624Z unit
3. AFBR-1624Z/AFBR-2624Z datasheet
4. HFBR-RNS001Z 1m Simples POF Fiber
5. User guide document
Evaluation Board
The basic evaluation board that you receive from Avago
incorporates passive components and connectors for di-
rect TTL input and output. This basic evaluation board al-
lows you to connect TTL sources with TTL sinks directly.
The boards are intended for drop in customer test setups
to allow the use of the Versatile Link AFBR-1624Z and
AFBR-2624Z parts in existing application without major
design modifications.
Bidirectional links require two sets of AFBR-0548Z and
HFBR-RNS001Z simplex.
For unidirectional links the TX and RX PCB’s can be sepa-
rated along the dotted line.
For more detailed system analysis it is recommended to
use the evaluation board AFBR-0546.
Initial Setup
1. Connect 3.3V or 5V supply voltage to 3.3V/5V pin of 3
pin connector
2. Connect 0V to GND pin of 3 pin connector
3. Connect TTL_In to pattern generator output
4. Connect TTL_Out to Oscilloscope or Bit Error Tester
with high impedance input.
5. For use at data rates between 10MBd and 50MBd the
use of SMA connectors (not included) is advisable.