AFBR-0546Z Datasheet, PDF (1/2 Pages) AVAGO TECHNOLOGIES LIMITED – AFBR-1624Z and AFBR-2624Z unit

AFBR-0546Z and AFBR-0547Z Evaluation Kit
DC to 50MBd 650nm Versatile Link
Fiber Optic Evaluation Kit
User Guide
Introduction
AFBR-0546Z is used to evaluate Avago fiber optics device
AFBR-1624Z and AFBR-2624Z.
AFBR-0547Z is used to evaluate Avago fiber optics device
AFBR-1629Z and AFBR-2529Z.
The evaluation kit is equipped with necessary documents
and accessories to ease production and verification.
Evaluation Kit
AFBR-0546Z contains:
1. Evaluation board
2. AFBR-1624Z and AFBR-2624Z unit
3. AFBR-1624Z/AFBR-2624Z datasheet
4. HFBR-RNS001Z 1m Simples POF Fiber
5. User guide document
AFBR-0547Z contains:
1. Evaluation board
2. AFBR-1629Z and AFBR-2529Z unit
3. AFBR-1629Z/AFBR-2529Z datasheet
4. HFBR-RNS001Z 1m Simples POF Fiber
5. User guide document
Evaluation Board
The basic evaluation board that you receive from Avago
incorporates passive components and SMA connectors
for the TX input (TXD) and RX output (RXD port connec-
tion. This basic evaluation board allows you to connect
waveform/pattern generators to the TXD with TTL input
signal. Receiver’s output signal can be monitored from
RXD or RXout with oscilloscope using 50Ohm input set-
ting. The logic of AFBR-1624Z/AFBR-2624Z (output high
when input high) and AFBR-1629Z/AFBR-2529Z (output
low when input high) is inverted.
Initial Setup
1. Connect 3.3V or 5V supply voltage to TXVCC and RXVCC
2. Connect 0V to TXGND and RXGND
3. Connect TXD to pattern generator output
4. Connect RXout or RXD to Oscilloscope or Bit Error
Tester with 50Ohm impedance input.