AFBR-0544Z Datasheet, PDF (1/4 Pages) AVAGO TECHNOLOGIES LIMITED – Evaluation PCB description

AFBR-0544Z Evaluation Kit for the
AFBR-5972Z Fiber Optic Transceiver
Application Note 5532
Evaluation Board
The AFBR-0544Z evaluation board gives the system
designer a convenient means to evalute the performance
of the Avago AFBR-5972Z fiber optic transceiver module,
as well as future compatible products.
As shown in Figure 1, the evaluation board is mounted with
an AFBR-5972Z module, four SMA connectors for differen-
tial input/output signals, a 2-pin header for measuring RF
differential signals using a differential probe, and three 2
mm jacks for the 3.3 V supply voltage and signal detect
(SD).
This application note describes the evaluation printed
circuit board (PCB), the test equipment, and the methods
for evaluating optical and electrical characteristics of the
the AFBR-5972Z transceiver module.
Figure 1. Evaluation board for the AFBR-5972Z transceiver module
Application Note Outline
1. Evaluation kit
2. Evaluation PCB description
3. Electro-optical test configurations
4. Evaluation board schematic and bill of materials
(BOM)
1. Evaluation kit
The AFBR-0544Z evaluation kit includes:
(a) Evaluation board with AFBR-5972Z module, four
SMA connectors, 2-pin header and three 2 mm jack
connectors and electronic components mounted on
bottom side of PCB
(b) 1 m simplex POF cable (NA = 0.5)
- P/No. HFBR-RNS001Z
(c) AFBR-4526Z duplex connector for AFBR-5972Z
(d) 1 m POF, with two AFBR-4526Z duplex connectors
- P/No. HFBR-RSD001Z
(To demonstrate only the mechanical properties of
the duplex connector)
Not included in the evaluation kit are:
(a) 3.3 V DC power supply and power supply cables
(b) Digitial multimeter
(c) MPI 1632C Digital Data Analyzer (Pattern generator)
(d) SDA 600A serial data analyzer (Oscilloscope)
(e) Femto (O/E) converter
(f ) Differential probe