ACPL-P345 Datasheet, PDF (1/15 Pages) AVAGO TECHNOLOGIES LIMITED – 1.0 Amp Output Current Power & SiC MOSFET Gate Drive Optocoupler with Rail-to-Rail Output Voltage in Stretched SO6

ACPL-P345 and ACPL-W345
1.0 Amp Output Current Power & SiC MOSFET Gate Drive Optocoupler
with Rail-to-Rail Output Voltage in Stretched SO6
Data Sheet
Description
The ACPL-P345/W345 contains an AlGaAs LED, which is
optically coupled to an integrated circuit with a power
output stage. This optocoupler is ideally suited for driving
power and SiC(Silicon Carbide) MOSFETs used in inverter
or AC-DC/DC-DC converter applications. The high operat-
ing voltage range of the output stage provides the drive
voltages required by gate controlled devices. The voltage
and high peak output current supplied by this optocou-
pler make it ideally suited for direct driving MOSFETs at
high frequency for high efficiency conversion. The ACPL-
P345 and ACPL-W345 have the highest insulation voltage
of V_IORM= 891Vpeak and V_IORM= 1140V_peak respectively in
the IEC/ EN/DIN EN 60747-5-5.
Functional Diagram
ANODE 1
NC 2
CATHODE 3
6 _VCC
5 V_OUT
4 V_EE
Note: A 1 µF bypass capacitor must be connected between pins V_CC and
V_EE.
Truth Table
V_CC – V_EE
“POSITIVE GOING”
LED (i.e., TURN-ON)
OFF
0 - 20 V
ON
0 – 8.1 V
ON
8.1 – 9.1 V
ON
9.1 – 20V
V_CC – V_EE
“NEGATIVE GOING”
(i.e., TURN-OFF)
0 – 20 V
0 – 7.1 V
7.1 – 8.1 V
8.1 – 20 V
V_O
LOW
LOW
TRANSITION
HIGH
Features
• 1.0 A maximum peak output current
• 0.8 A minimum peak output current
• Rail-to-rail output voltage
• 120 ns maximum propagation delay
• 50 ns maximum propagation delay difference
• LED current input with hysteresis
• 50 kV/µs minimum Common Mode Rejection (CMR) at
V_CM = 1500 V
• I_CC = 4.0 mA maximum supply current
• Under Voltage Lock-Out protection (UVLO) with
hysteresis
• Wide operating V_CC Range: 10 to 20 V
• Industrial temperature range: -40 °C to 105 °C
• Safety Approval
- UL Recognized 3750/5000 V_RMS for 1min.
- CSA
- IEC/EN/DIN EN 60747-5-5 V_IORM = 891/1140 V_peak
Applications
• Power and SiC MOSFET gate drive
• AC and Brushless DC motor drives
• Switching power supplies
CAUTION: It is advised that normal static precautions be taken in handling and assembly
of this component to prevent damage and/or degradation which may be induced by ESD.