ACPL-M49U Datasheet, PDF (1/10 Pages) AVAGO TECHNOLOGIES LIMITED – Low Speed Digital Signal isolation Interface

ACPL-M49U
Wide Operating Temperature R²Coupler^TM 20kBd Digital Optocoupler
Configurable as Low Power, Low Leakage Phototransistor
Data Sheet
Lead (Pb) Free
RoHS 6 fully
compliant
RoHS 6 fully compliant options available;
-xxxE denotes a lead-free product
Description
The ACPL-M49U is a single channel, high temperature,
high CMR, 20kBd digital optocoupler, configurable as a
low power, low leakage phototransistor, specifically for
use in industrial applications. The SO-5 JEDEC registered
(MO-155) package outline is surface mountable.
This digital optocoupler uses an insulating layer between
the light emitting diode and an integrated photo detector
to provide electrical insulation between input and output.
Separate connections for the photodiode bias and output
transistor collector in a 5-pin configuration increase
the speed up to a hundred times over that of a conven-
tional phototransistor by reducing the base-collector
capacitance. Common connections with the supply and
output pins shorted in a 4-pin configuration delivers low
power, low leakage performance as a phototransistor. The
ACPL-M49U has an increased common mode transient
immunity of 15kV/s minimum at V_CM = 1500V over
extended temperature range.
Avago R²Coupler isolation products provide the rein-
forced insulation and reliability needed for critical in high
temperature industrial applications.
Features
 High Temperature and Reliable low speed digital
interface for Industrial Application.
 30 kV/s High Common-Mode Rejection atV_CM = 1500V
(typ)
 Low Power, Low Leakage Phototransistor in a 4-Pin
Configuration
 Compact, Auto-Insertable SO5 Packages
 Wide Temperature Range: -40°C ~ 125°C
 Low LED Drive Current: 4mA (typ)
 Propagation Delay: 20s (max)
 Worldwide Safety Approval:
– UL 1577, 3750 V_RMS /1 min.
– CSA File CA88324, Notice #5
– IEC/EN/DIN EN 60747-5-5
Applications
 Low Speed Digital Signal isolation Interface
 Inverter fault feedback signal isolation
 Switching Power Supplies feedback circuit
Functional Diagrams
+
ANODE
1
SHIELD
I_F
V_F
-
CATHODE
3
I_{CC 6}
V_CC
I_{O 5}
V_O
4
GND
+
ANODE
1
SHIELD
I_F
V_F
-
CATHODE
3
I_CC
6
V_CC
I_O
4
GND
LED
Vo
ON
LOW
OFF HIGH
Note: The connection of a 0.1 F bypass capacitor
between pins 4 and 6 is recommended for 5-pin
configuration
Note: Pins 5 and 6 are externally shorted for 4-pin
configuration.
CAUTION: It is advised that normal static precautions be taken in handling and assembly
of this component to prevent damage and/or degradation which may be induced by ESD.