ACPL-M49T Datasheet, PDF (1/10 Pages) AVAGO TECHNOLOGIES LIMITED – Low Leakage Phototransistor

ACPL-M49T
Wide Operating Temperature Automotive R²Coupler^TM 20kBd Digital
Optocoupler Configurable as Low Power, Low Leakage Phototransistor
Data Sheet
Lead (Pb) Free
RoHS 6 fully
compliant
RoHS 6 fully compliant options available;
-xxxE denotes a lead-free product
Description
The ACPL-M49T is a single channel, high temperature,
high CMR, 20kBd digital optocoupler, configurable as a
low power, low leakage phototransistor, specifically for
use in the automotive applications. The SO-5 JEDEC regis-
tered (MO-155) package outline is surface mountable.
This digital optocoupler uses an insulating layer between
the light emitting diode and an integrated photo detector
to provide electrical insulation between input and output.
Separate connections for the photodiode bias and output
transistor collector in a 5-pin configuration increase
the speed up to a hundred times over that of a conven-
tional phototransistor by reducing the base-collector
capacitance. Common connections with the supply and
output pins shorted in a 4-pin configuration delivers low
power, low leakage performance as a phototransistor. The
ACPL-M49T has an increased common mode transient
immunity of 15kV/s minimum at V_CM = 1500V over
extended temperature range.
Avago R²Coupler isolation products provide the reinforced
insulation and reliability needed for critical in automotive
and high temperature industrial applications.
Functional Diagrams
Features
 High Temperature and Reliable low speed digital
interface for Automotive Application.
 30 kV/s High Common-Mode Rejection atV_CM = 1500V
(typ)
 Low Power, Low Leakage Phototransistor in a 4-Pin
Configuration"
 Compact, Auto-Insertable SO5 Packages
 Wide Temperature Range: -40°C ~ 125°C
 Low LED Drive Current: 4mA (typ)
 Propagation Delay: 20s (max)
 Worldwide Safety Approval:
– UL 1577, 4000 V_RMS /1 min.
– CSA File CA88324, Notice #5
– IEC/EN/DIN EN 60747-5-2
 Qualified to Automotive AEC-Q100 Grade 1 Stress Test
Guidelines
Applications
 Automotive Low Speed Digital Signal isolation Interface
 Inverter fault feedback signal isolation
 Switching Power Supplies feedback circuit
+
ANODE
1
SHIELD
I_F
V_F
-
CATHODE
3
I_{CC 6}
V_CC
I_{O 5}
V_O
4
GND
+
ANODE
1
SHIELD
I_F
V_F
-
CATHODE
3
I_CC
6
V_CC
I_O
4
GND
LED
Vo
ON
LOW
OFF HIGH
Note: The connection of a 0.1 F bypass capacitor
between pins 4 and 6 is recommended for 5-pin
configuration
Note: Pins 5 and 6 are externally shorted for 4-pin
configuration.
CAUTION: It is advised that normal static precautions be taken in handling and assembly
of this component to prevent damage and/or degradation which may be induced by ESD.