ACNT-H61L Datasheet, PDF (1/2 Pages) AVAGO TECHNOLOGIES LIMITED – Medical imaging and patient monitoring

ACNT-H61L
Low Power 10 MBd Digital CMOS Optocoupler
in 14.2 mm Creepage/Clearance Stretched SO8 Package
Product Brief - Preliminary
(ALL SPECIFICATIONS ARE TARGETED SPECIFICATIONS AND ARE SUBJECTED TO CHANGES BEFORE FINAL
PRODUCTION RELEASE. AVAGO RESERVES THE FINAL DECISION TO RELEASE THE PRODUCT TO PRODUCTION.)
Description
Features
PRELIMINARY ^{DATA The ACNT-H61L is a stretched wide optically coupled op-}
tocoupler that combines an AlGaAs light-emitting diode
and an integrated high gain photo detector to address
low power need for isolated interface. The optocoupler
consumes extremely low power, at maximum 2 mA across
temperature. The LED forward current operates from 5
mA.
This optocoupler supports both 3.3 V and 5 V supply volt-
age with guaranteed AC and DC operational parameters
from temperature range -40 °C to +105 °C. The output
of the detector IC is a CMOS output. The internal Faraday
shield provides a guaranteed common mode transient
immunity specification of 20 kV/µs.
ACNT-H61L of 14.2 mm creepage/clearance and high volt-
age insulation capability suit for isolated communicate
logic interface and control in high-voltage power sys-
tems such as 690 V_AC drives, renewable inverters, medical
equipment.
Functional Diagram
NC ₁
TRUTH TABLE
8 VDD _{(POSITIVE LOGIC)}
• Low I_DD power supply consumption: 2 mA max.
• Input current capability: 5 mA min.
• Package: Stretched SO-8
• 20 kV/µs minimum Common Mode Rejection (CMR) at
V_CM = 1000 V
• High Speed: 10 MBd min.
• Guaranteed AC and DC performance over wide
temperature: -40 °C to +105 °C
• Safety Approval (Pending)
- UL 1577 recognized - 7500 V_rms for 1 minute
- CSA Approval
- IEC/EN/DIN EN 60747-5-5 V_IORM = 2262 V_peak for
Reinforced Insulation
Applications
• Communication Interface: RS-485, CAN Bus
• Digital isolation for A/D, D/A conversion
• High-voltage power systems, e.g., 690 V drives
• Renewable energy inverters
• Medical imaging and patient monitoring
Anode 2
7 NC
LED OUTPUT V_o
Cathode 3
6 Vo
ON
L
OFF
H
NC _{4 Shield}
5 GND
A 0.1 µF bypass capacitor must be connected between pins V_DD and GND
This preliminary data is provided to assist you in the evaluation of product(s) currently under development. Until
Avago Technologies releases this product for general sales, Avago Technologies reserves the right to alter prices,
specifications, features, capabilities, functions, release dates, and remove availability of the product(s) at anytime.
CAUTION: It is advised that normal static precautions be taken in handling and assembly
of this component to prevent damage and/or degradation which may be induced by ESD.