CWT-PCB Datasheet, PDF (1/1 Pages) Advanced Thermal Solutions, Inc. – TEST MULTIPLE PCBs IN WIND TUNNEL

OPEN LOOP WIND TUNNEL
CWT-PCB™
TEST MULTIPLE PCBs IN WIND TUNNEL
A unique, fully controllable wind tunnel for thermal
and air flow testing of multiple PCBs. The test
chamber has a 2-D converging nozzle with a multi-point
measurement area for sensor placement upstream of the
test section. The test section is equipped with card guides
to allow insertion of actual or simulated PCBs from the
side panel.
The wind tunnel is designed to test up to six PCBs side
by side as seen in a electronic cabinet. The wind tunnel
can also be used for standard thermal characterization
such as component, PCBs, cold plates, etc.
The chamber can accommodate up to 6 PCBs with
13 mm (0.5") card-to-card spacing or 3 PCBs with
25 mm (1") card-to-card spacing.
The test section is made of clear polycarbonate
material to accommodate smoke flow visualization.
The chamber has its own stand for placement
of instruments. The CWT-PCB™ is placed on
castors for ease of transportation.
The CWT-PCB™ can be fitted with different
fan trays to accommodate a broad air flow
range. Heating elements can be added for
elevated air temperature testing.
* Power supply not included.
RECOMMENDED ACCESSORIES:
WTC-100^TM
Wind Tunnel Controller
ATVS-NxT^TM
Hot Wire Anemometer
HP-97^TM
High Power Component Simulator
OVERALL DIMENSIONS (L X W X D)
215.5 x 114.3 x 91.4 cm
(84.45 x 45 x 35.96")
TEST SECTION
60.96 x 47 x 7.62 cm
(24 x 18.5 x 3")
NUMBER OF SENSOR PORTS
18
FLOW RANGE
0 to 10 m/s (0 to 2000 ft/min)
WEIGHT
74kg (164 lbs)
POWER SUPPLY REQUIREMENTS
24VDC at 4.33 Amps
For further technical information, please contact Advanced Thermal
Solutions, Inc. at 1-781-769-2800 or www.qats.com
FEATURES:
» Multiple PCB Testing
Test actual or simulated PCBs for
thermal and air flow distribution
» H eat Sink Characterization
Characterize a variety of heat
sink sizes for natural and forced
convection cooling
» Sensor Calibration
Uniform velocity profile at the
testing section allows accurate
calibration of sensors
» Heat Sink Comparison
Multiple PCBs testing simulated
up to six PCBs in parallel
» Component Testing
An ideal test vehicle for
component characterization
» Flow Visualization
Observe air flow distribution
in the tunnel by smoke or
buoyant bubbles through the
all Plexiglas^TM test section
» V ariable Speed
Change air flow rates by
controlling the fan RPM
» Quick Access
Quickly change the test
specimen through the test
section cover and side access
» Sensor Ports
Measure pressure, velocity
and temperature through
the sensor ports
» Free Lifetime Tech Support
APPLICATIONS:
» Telecommunications
» A utomotive
» Medical
» Chemical
» University Research
89-27 ACCESS ROAD, NORWOOD, MA 02062 USA | T: 781.769. 2800 F: 781.769.9979 | WWW.QATS.COM
R3_0215