ATR0630P1 Datasheet, PDF (7/14 Pages) ATMEL Corporation – ANTARIS4 Single-chip GPS Receiver

ATR0630P1
Table 3-1. ATR0630P1 Pinout (Continued)
Pin Name BGA 96
Pin Type
Pull Resistor
(Reset Value)⁽¹⁾
Firmware Label
PIO Bank A
I
O
GNDA
B4
Supply
GNDA
D2
Supply
GNDA
E1
Supply
GNDA
E2
Supply
GNDA
E3
Supply
GNDA
F1
Supply
GNDA
F2
Supply
GNDA
F3
Supply
GNDA
G1
Supply
GNDA
H1
Supply
LDOBAT_IN D11
Supply
LDO_EN C11
Digital IN
LDO_IN E11
Supply
LDO_OUT E12
Supply
MO
C3
Analog OUT
NRESET
A7
Digital I/O
Open Drain PU
NRF
C1
Analog IN
NSHDN
E9
Digital OUT
NSLEEP E10
Digital OUT
NTRST
H11
Digital IN
PD
NX
B2
Analog OUT
NXTO
B3
Analog IN
P0
C8
Digital I/O
PD
NANTSHORT
P1
D8
Digital I/O Configurable (PD)
GPSMODE0
P2
C6
Digital I/O Configurable (PD)
BOOT_MODE
‘0’
P8
D7
Digital I/O Configurable (PD)
STATUSLED
‘0’
P9
A11
Digital I/O
PU to VBAT18
EXTINT0
EXTINT0
P12
D6
Digital I/O Configurable (PU)
GPSMODE2
NPCS2
P13
B10
Digital I/O
PU to VBAT18
GPSMODE3
EXTINT1
P14
G6
Digital I/O Configurable (PD)
NAADET1
‘0’
P15
F11
Digital I/O
PD
ANTON
P16
G8
Digital I/O Configurable (PU)
NEEPROM
P17
H6
Digital I/O Configurable (PD)
GPSMODE5
SCK1
SCK1
P18
C7
Digital I/O Configurable (PU)
TXD1
TXD1
P19
F6
Digital I/O Configurable (PU)
GPSMODE6
Notes: 1. PD = internal pull-down resistor, PU = internal pull-up resistor, OH = switched to Output High at reset
2. VBAT18 represent the internal power supply of the backup power domain.
3. VDD_USB is the supply voltage for following the USB pins: USB_DM and USB_DP. For operation of the USB interface, sup-
ply of 3.0V to 3.6V is required.
4. VDDIO is the supply voltage for the following GPIO pins: P1, P2, P8, P12, P14, P16, P17, P18, P19, P20, P21, P23, P24,
P25, P26, P27 and P29.
7
4978AS–GPS–12/07