T2526_09 Datasheet, PDF (6/14 Pages) ATMEL Corporation – Low-voltage IR Receiver ASSP

6. Electrical Characteristics, 5-V Operation (Continued)
T_amb = 25°C, V_S = 5V unless otherwise specified.
No. Parameters
Test Conditions
Pin Symbol Min.
Typ. Max. Unit Type*
7 Input
7.1 Input DC current
V_IN = 0
See Figure 7-10 on page 10
5
I_{IN_DCMAX}
–400
µA
C
7.2
Input DC-current
See Figure 7-4 on page
8
V_IN = 0; Vs = 5V
T_amb = 25°C
5
I_{IN_DCMAX}
–700
µA
B
Min. detection
Test signal:
7.3
threshold current
See Figure 7-9 on page 10
See Figure 7-2 on page V_S = 5V
3
7
T_amb = 25°C
Min. detection
I_{IN_DC} = 1 µA
square pp
threshold current with _{burst N = 16}
7.4
AC current disturbance
IIN_AC100 = 3 µA at
f = f₀; t_PER = 10 ms
Figure 7-8 on page 9
3
100 Hz
BER = 50⁽²⁾
I_Eemin
I_Eemin
–850
–2000
pA
B
pA
C
Test signal:
See Figure 7-9 on page 10
Max. detection
V_S = 5V, T_amb = 25° C I_{IN_DC} =
1 µA
7.5 threshold current with square pp
3
V_IN > 0V
burst N = 16
f = f₀; t_PER = 10 ms
Figure 7-8 on page 9
BER = 5%⁽²⁾
I_Eemax
–500
µA
D
8 Controlled Amplifier and Filter
8.1
Maximum value of
variable gain (CGA)
G_VARMAX
51
dB
D
8.2
Minimum value of
variable gain (CGA)
G_VARMIN
–5
dB
D
8.3
Total internal
amplification⁽³⁾
G_MAX
71
dB
D
Resulting center
8.4 frequency fusing
accuracy
f₀ fused at V_S = 3V
V_S = 5V, T_amb = 25°C
f_05V
f_03V-FUSE
+ 0.5
%
A
*) Type means: A =100% tested, B = 100% correlation tested, C = Characterized on samples, D = Design parameter
Notes: 1. Depending on version, see “Ordering Information”
2. BER = bit error rate; e.g., BER = 5% means that with P = 20 at the input pin 19...21 pulses can appear at the pin OUT
3. After transformation of input current into voltage
6.1 ESD
All pins ⇒2000V HBM; 200V MM, MIL-STD-883C, Method 3015.7
6.2 Reliability
Electrical qualification (1000h) in molded plastic package
6 T2526
4597H–AUTO–09/09