ATMEGA165V_06 Datasheet, PDF (6/19 Pages) ATMEL Corporation – 8-bit Microcontroller with 16K Bytes In-System Programmable Flash

Port G (PG4..PG0)
RESET
XTAL1
XTAL2
AVCC
AREF
tors on pins PF7(TDI), PF5(TMS), and PF4(TCK) will be activated even if a reset
occurs.
Port F also serves the functions of the JTAG interface.
Port G is a 5-bit bi-directional I/O port with internal pull-up resistors (selected for each
bit). The Port G output buffers have symmetrical drive characteristics with both high sink
and source capability. As inputs, Port G pins that are externally pulled low will source
current if the pull-up resistors are activated. The Port G pins are tri-stated when a reset
condition becomes active, even if the clock is not running.
Port G also serves the functions of various special features of the ATmega165 as listed
on page 66.
Reset input. A low level on this pin for longer than the minimum pulse length will gener-
ate a reset, even if the clock is not running. The minimum pulse length is given in Table
16 on page 38. Shorter pulses are not guaranteed to generate a reset.
Input to the inverting Oscillator amplifier and input to the internal clock operating circuit.
Output from the inverting Oscillator amplifier.
AVCC is the supply voltage pin for Port F and the A/D Converter. It should be externally
connected to V_CC, even if the ADC is not used. If the ADC is used, it should be con-
nected to V_CC through a low-pass filter.
This is the analog reference pin for the A/D Converter.
6 ATmega165/V
2573FS–AVR–08/06