AT90USB162-16AU Datasheet, PDF (52/307 Pages) ATMEL Corporation – 8-bit Microcontroller with 8/16K Bytes of ISP Flash and USB Controller

9.8 Internal Voltage Reference
AT90USB82/162 features an internal bandgap reference. This reference is used for Brown-out
Detection, and it can be used as an input to the Analog Comparator.
9.8.1
Voltage Reference Enable Signals and Start-up Time
The voltage reference has a start-up time that may influence the way it should be used. The
start-up time is given in Table 9-4. To save power, the reference is not always turned on. The
reference is on during the following situations:
1. When the BOD is enabled (by programming the BODLEVEL [2..0] Fuse).
2. When the bandgap reference is connected to the Analog Comparator (by setting the
ACBG bit in ACSR).
Thus, when the BOD is not enabled, after setting the ACBG bit, the user must always allow the
reference to start up before the output from the Analog Comparator is used. To reduce power
consumption in Power-down mode, the user can avoid the three conditions above to ensure that
the reference is turned off before entering Power-down mode
.
Table 9-4. Internal Voltage Reference Characteristics
Symbol Parameter
Condition
Min Typ Max Units
V_BG Bandgap reference voltage
t_BG
Bandgap reference start-up time
I_BG
Bandgap reference current
consumption
V_CC = 2.7V - 5.5V 1.0 1.1 1.2
V
-
40 70 µs
-
10
µA
9.9 Watchdog Timer
AT90USB82/162 has an Enhanced Watchdog Timer (WDT). The main features are:
• Clocked from separate On-chip Oscillator
• 3 Operating modes
– Interrupt
– System Reset
– Interrupt and System Reset
52 AT90USB82/162
7707F–AVR–11/10