ATMEGA32_08 Datasheet, PDF (42/346 Pages) ATMEL Corporation – 8-bit Microcontroller with 32K Bytes In-System Programmable Flash

Watchdog Timer
Control Register –
WDTCR
Bit
7
6
5
4
3
2
1
0
–
–
–
WDTOE WDE
WDP2 WDP1 WDP0 WDTCR
Read/Write
R
R
R
R/W
R/W
R/W
R/W
R/W
Initial Value
0
0
0
0
0
0
0
0
• Bits 7..5 – Res: Reserved Bits
These bits are reserved bits in the ATmega32 and will always read as zero.
• Bit 4 – WDTOE: Watchdog Turn-off Enable
This bit must be set when the WDE bit is written to logic zero. Otherwise, the Watchdog will not
be disabled. Once written to one, hardware will clear this bit after four clock cycles. Refer to the
description of the WDE bit for a Watchdog disable procedure.
• Bit 3 – WDE: Watchdog Enable
When the WDE is written to logic one, the Watchdog Timer is enabled, and if the WDE is written
to logic zero, the Watchdog Timer function is disabled. WDE can only be cleared if the WDTOE
bit has logic level one. To disable an enabled Watchdog Timer, the following procedure must be
followed:
1. In the same operation, write a logic one to WDTOE and WDE. A logic one must be writ-
ten to WDE even though it is set to one before the disable operation starts.
2. Within the next four clock cycles, write a logic 0 to WDE. This disables the Watchdog.
• Bits 2..0 – WDP2, WDP1, WDP0: Watchdog Timer Prescaler 2, 1, and 0
The WDP2, WDP1, and WDP0 bits determine the Watchdog Timer prescaling when the Watch-
dog Timer is enabled. The different prescaling values and their corresponding Timeout Periods
are shown in Table 17.
Table 17. Watchdog Timer Prescale Select
WDP2 WDP1 WDP0
Number of WDT
Oscillator Cycles
0
0
0
16K (16,384)
0
0
1
32K (32,768)
0
1
0
64K (65,536)
0
1
1
128K (131,072)
1
0
0
256K (262,144)
1
0
1
512K (524,288)
1
1
0
1,024K (1,048,576)
1
1
1
2,048K (2,097,152)
Typical Time-out
at V_CC = 3.0V
17.1 ms
34.3 ms
68.5 ms
0.14 s
0.27 s
0.55 s
1.1 s
2.2 s
Typical Time-out
at V_CC = 5.0V
16.3 ms
32.5 ms
65 ms
0.13 s
0.26 s
0.52 s
1.0 s
2.1 s
42 ATmega32(L)
2503N–AVR–06/08