AT17N512_14 Datasheet, PDF (4/18 Pages) ATMEL Corporation – Simple Interface to SRAM FPGAs

Block Diagram
SER_EN
POWER ON
RESET
Device Description
The control signals for the configuration EEPROM (CE, RESET/OE and CCLK) inter-
face directly with the FPGA device control signals. All FPGA devices can control the
entire configuration process and retrieve data from the configuration EEPROM without
requiring an external intelligent controller.
The configuration EEPROM RESET/OE and CE pins control the tri-state buffer on the
DATA output pin and enable the address counter. When RESET/OE is driven High, the
configuration EEPROM resets its address counter and tri-states its DATA pin. The CE
pin also controls the output of the AT17N series configurator. If CE is held High after the
RESET/OE reset pulse, the counter is disabled and the DATA output pin is tri-stated.
When OE is subsequently driven Low, the counter and the DATA output pin are
enabled. When RESET/OE is driven High again, the address counter is reset and the
DATA output pin is tri-stated, regardless of the state of CE. Upon power-up, the address
counter is automatically reset.
4 AT17N256/512/010/002/040
3020C–CNFG–08/07