English
Language : 

ATA6612C_14 Datasheet, PDF (308/312 Pages) ATMEL Corporation – 8K/16K Flash Microcontroller with LIN Transceiver, 5V Regulator and Watchdog
11. Revision History
Please note that the following page numbers referred to in this section refer to the specific revision mentioned, not to this
document.
Revision No.
9111L-AUTO-11/14
9111K-AUTO-03/13
9111J-AUTO-11/12
9111I-AUTO-02/12
9111H-AUTO-01/11
9111G-AUTO-05/10
History
• Put datasheet in the latest template
• Section 8 “Ordering Information” on page 306 updated
• Section 9 “Package Information” on page 306 updated
• Section 2 “Pin Configuration” on pages 2 to 3 updated
• Table 3-1 “Maximum Ratings of the SIP” on page 4 updated
• Table 3-2 “Maximum Ratings of the LIN-SBC” on pages 4 to 5 added
• Table 3-3 “Maximum Ratings of the Microcontroller” on page 5 added
• Figure 8-1 “Typical LIN Slave Application” on page 351 updated
• Figure 8-2 “Typical LIN Master Application” on page 352 updated
• Figure 8-3 “LIN Slave Application with Minimum External Components” on page 353
updated
• Figure 8-4 “Typical LIN Master Application LIN Master Pull-up Switched Off during Sleep
Mode” on page 354 updated
• ATA6612P/ATA6613P renamed in ATA6612C/ATA6613C
• General Features on page 1 changed
• Section 3.1 “Features” on page 5 changed
• Section 3.3 “Functional Description” on pages 7 to 19 changed
• Section 4 “Absolute Maximum Ratings” on page 20 changed
• Section 5 “Electrical Characteristics” on page 21 changed
• Section 8 “Application” on pages 355 to 358 changed
• Section 3.1 “Features” on page 5 changed
• Section 3.3.3 “Ground Pin” on page 7 changed
• Section 3.3.12 “Mode Input Pin (Mode)” on page 8 changed
• Figure 3.2 “Modes of Operation” on page 10 changed
• Section 3.3.20.4 “Fail-safe Mode” on page 13 changed
• Section 3.3.23 “Voltage Regulator” on pages 16 to 17 changed
• Section 6 “Electrical Characteristics” on pages 21 to 26 changed
• Table 2-2 “Maximum Ratings of the SiP” on page 4 changed
• Section 3.1 “Features” on page 5 changed
• Section 3.2 “Description” on page 5 changed
• Section 3.3.1 “Physical Layer Compatibility” on page 7 changed
• Section 3.3.6 “Bus Pin LIN” on page 7 changed
• Section 3.3.8 “TX Dominant Time-out Function” on page 8 changed
• Section 3.3.10 “Enable Input Pin (EN)” on page 8 changed
• Section 3.3.14 “KL_15 Pin” on page 9 changed
• Section 3.3.20 “Modes of Operation” on pages 10 to 14 changed
• Section 3.3.21 “Wake-up Scenarios from Silent to Sleep Mode on page 15 changed
• Section 3.3.23 “Voltage Regulator” on page 16 changed
• Section 6 “Electrical Characteristics” on page 23 changed
• Section 7.7.7.1 “Power Reduction Register” on page 66 changed
308 ATA6612C/ATA6613C [DATASHEET]
9111L–AUTO–11/14