AT88SC0104CRF_06 Datasheet, PDF (3/9 Pages) ATMEL Corporation – 13.56 MHz CryptoRF EEPROM Memory 1 Kbits

CRC Error Detection
Type A Tolerance
AT88SC0104CRF
The REQB command performs the same function but does not affect a PICC in the Halt
state. The CryptoRF command set is available only after the anticollision process has
been completed.
A two-byte CRC_B is required in each frame transmitted by the PICC or PCD to permit
transmission error detection. The CRC_B is calculated on all of the command and data
bytes in the frame. The SOF, EOF, start bits, stop bits, and EGT are not included in the
CRC_B calculation. The two-byte CRC_B follows the data bytes in the frame.
Figure 2. Location of the Two CRC_B Bytes within a Frame
SOF
K data bytes
CRC1 CRC2
EOF
The RF Interface is designed for use in multiprotocol applications. It will not latch or lock
up if exposed to Type A signals and will not respond to them. The PICC may reset in the
presence of Type A field modulation but is not damaged by exposure to Type A signals.
3
5021CS–CRRF–12/06