AT24C04B_14 Datasheet, PDF (25/28 Pages) ATMEL Corporation – 2-Wire Automotive Temperature Serial EEPROM

5TS1 – SOT23
Figure 19. 5TS1 – SOT23
e1
5
4
Two-wire Serial EEPROM
C
E1
E
CL
1
2
3
Top View
b
L1
End View
A2 _A
Seating
Plane
e
A1
D
Side View
NOTES :
1. This d rawing is for gene ral information onl y. Refer to JEDEC D rawing
MO-193, Variation A B, for additional in formation.
2. Dimension D does not include mold flash, prot rusion s, or gate burrs.
Mold flash, prot rusion s, or gate burrs shall not exceed 0.15 mm per end.
Dimension E1 does not include inte rlead flash or prot rusion . Inte rlead
flash or prot rusion shall not exceed 0.15 mm per sid e.
3. The pa ckage top m ay be smaller than the pa ckage bottom . Dimensions
D and E1 are dete rmined at the oute rmost extremes of the plastic body
exclusi ve of mold flash, tie bar burrs, gate burrs, and inte rlead flash, but
including a ny mismatch bet ween the top and bottom of the plastic bod y.
4. These dimensions apply to the flat section of the lead bet ween 0.08 mm
and 0.15 mm from the lead ti p.
5. Dimension "b" does not include Dambar prot rusion . Allowable Dambar
protrusion shall be 0.08 mm total in excess of the "b" dimension at
maxi mum mate rial condition . The Dambar cannot be located on the l ower
radius of the foot. Mini mum space bet ween prot rusion and an adjacent lead
shall not be less than 0.07 mm.
SYMBOL
A
A1
A2
c
D
E
E1
L1
e
e1
b
COMMON DIMENSIONS
(Unit of Measure = mm)
MIN
–
0.0 0
0.7 0
0.0 8
0.3 0
NOM
MAX
–
1.10
–
0.10
0.9 0
1.00
–
0.2 0
2.90 BS C
2.80 BS C
1.60 BS C
0.60 REF
0.95 BSC
1.90 BSC
–
0.5 0
NOTE
4
2, 3
2, 3
2, 3
4, 5
1150 E . Cheyenne Mtn . Blvd.
R Colorado Sp rings, CO 80906
TITLE
5TS1, 5-lead, 1.60 mm Body, Plastic Thin Shrink
Small Outline Package (SHRINK SOT)
6/25/03
DRAWING NO. REV.
PO5TS1
A
5226G–SEEPR–11/09
25