AT24C16B_09 Datasheet, PDF (23/27 Pages) ATMEL Corporation – Two-wire Serial EEPROM

12.5 5TS1 – SOT23
e1
5
4
AT24C16B
C
E1
E
CL
1
2
3
Top View
b
L1
End View
A2 _A
Seating
Plane
e
A1
D
Side View
NOTES:
1. This drawing is for general information only. Refer to JEDEC Drawing
MO-193, Variation AB, for additional information.
2. Dimension D does not include mold flash, protrusions, or gate burrs.
Mold flash, protrusions, or gate burrs shall not exceed 0.15 mm per end.
Dimension E1 does not include interlead flash or protrusion. Interlead
flash or protrusion shall not exceed 0.15 mm per side.
3. The package top may be smaller than the package bottom. Dimensions
D and E1 are determined at the outermost extremes of the plastic body
exclusive of mold flash, tie bar burrs, gate burrs, and interlead flash, but
including any mismatch between the top and bottom of the plastic body.
4. These dimensions apply to the flat section of the lead between 0.08 mm
and 0.15 mm from the lead tip.
5. Dimension "b" does not include Dambar protrusion. Allowable Dambar
protrusion shall be 0.08 mm total in excess of the "b" dimension at
maximum material condition. The Dambar cannot be located on the lower
radius of the foot. Minimum space between protrusion and an adjacent lead
shall not be less than 0.07 mm.
COMMON DIMENSIONS
(Unit of Measure = mm)
SYMBOL
A
A1
A2
c
D
E
E1
L1
e
e1
b
MIN
–
0.00
0.70
0.08
0.30
NOM MAX
–
1.10
–
0.10
0.90
1.00
–
0.20
2.90 BSC
2.80 BSC
1.60 BSC
0.60 REF
0.95 BSC
1.90 BSC
–
0.50
NOTE
4
2, 3
2, 3
2, 3
4, 5
1150 E. Cheyenne Mtn. Blvd.
R Colorado Springs, CO 80906
TITLE
5TS1, 5-lead, 1.60 mm Body, Plastic Thin Shrink
Small Outline Package (SHRINK SOT)
6/25/03
DRAWING NO. REV.
PO5TS1
A
23
5175E–SEEPR–3/09