STK526 Datasheet, PDF (22/40 Pages) ATMEL Corporation – AT90USB82/162 TQFP device (2.7V

Using the STK526
Parallel High-Voltage The STK526 is compatible with the Parallel Programming mode of the STK500. The
Programming embedded RESET circuitry supports the HighVoltage pulses used during programming.
Once the STK526 is plugged into the STK500 Expand connectors, the following
configuration must be set before powering the boards :
On the STK526 :
– set the primary power source (Vcc Src jumper) to STK and REG 5V
– set the 3V3REG jumper to “NOREG”
– mount the jumper STKX1 to enable the STK500 clock signal
On the STK500 :
– connect the PROG_CTRL header (10 pts) to the PORTD header (10pts)
– connect the PROG_DATA header (10 pts) to the PORTB header (10pts)
– mount the following jumpers : VTARGET, RESET, XTAL1, BSEL2
– mount a jumper on the position 1-2 (= right side) of the OSCSEL header
All the Flash memory, EEPROM, all Fuse and Lock Bit can be programmed individually
or with the sequential automatic programming option.
Figure 2-24 . Connecting STK526 to STK500 for High Voltage Parallel Programming
STK526 rev. B Hardware User Guide
2-21
7709B–AVR–07/08