ATZB-24-B0_14 Datasheet, PDF (21/25 Pages) ATMEL Corporation – ZIGBIT 2.4GHZ WIRELESS MODULES

4. Agency Certifications
4.1 United States (FCC)
This equipment complies with Part 15 of the FCC rules and regulations.
To fulfill FCC Certification requirements, an OEM manufacturer must comply with the following regulations:
1. The modular transmitter must be labeled with its own FCC ID number, and, if the FCC ID is not visible when
the module is installed inside another device, then the outside of the device into which the module is installed
must also display a label referring to the enclosed module. This exterior label can use wording such as the
following:
Example of label required for OEM product containing ATZB-24-A2 module
Contains FCC ID: VW4A090664
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (i.) this device may not cause harmful interference and (ii.) this device must accept any interference
received, including interference that may cause undesired operation.
Example of label required for OEM product containing ATZB-24-B0 module
Contains FCC ID: VW4A090665
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (i.) this device may not cause harmful interference and (ii.) this device must accept any interference
received, including interference that may cause undesired operation.
Any similar wording that expresses the same meaning may be used.
ATZB-24-A2 module is Modular approved and does not need separate approval for this module when used on an
application board
ATZB-24-B0 is limited modular approved and required separate approval for this module when used on an
application board
4.2 Canada (IC)
ATZB-24-A2 Module complies with Industry Canada specifications RSS-210 and RSS – Gen
IC ID for ATZB-24-A2 is 11019A-090664
ATZB-24-A2 module is Modular approved and does not need separate approval for this module when used on an
application board
4.3 European Union (ETSI)
The ATZB-24-A2 and ATZB-24-B0 Modules has been certified for use in European Union countries.
If the ATZB-24-A2 and ATZB-24-B0 Modules are incorporated into a product, the manufacturer must ensure compliance
of the final product to the European harmonized EMC and low-voltage/safety standards. A Declaration of Conformity
must be issued for each of these standards and kept on file as described in Annex II of the R&TTE Directive.
ATZB-24-A2/B0 [ZigBit 2.4GHz Wireless Modules] ²¹
8226C−AVR−07/2013