ATMEGA8_06 Datasheet, PDF (20/23 Pages) ATMEL Corporation – 8-bit AVR with 8K Bytes In-System Programmable Flash

Changes from Rev.
2486H-09/02 to Rev.
2486I-12/02
Changes from Rev.
2486G-09/02 to Rev.
2486H-09/02
Changes from Rev.
2486F-07/02 to Rev.
2486G-09/02
3. Corrected OCn waveforms in Figure 38 on page 90.
4. Various minor Timer 1 corrections.
5. Various minor TWI corrections.
6. Added note under “Filling the Temporary Buffer (Page Loading)” on page 216
about writing to the EEPROM during an SPM Page load.
7. Removed ADHSM completely.
8. Added section “EEPROM Write during Power-down Sleep Mode” on page 23.
9. Removed XTAL1 and XTAL2 description on page 5 because they were already
described as part of “Port B (PB7..PB0) XTAL1/XTAL2/TOSC1/TOSC2” on
page 5.
10. Improved the table under “SPI Timing Characteristics” on page 246 and
removed the table under “SPI Serial Programming Characteristics” on page
241.
11. Corrected PC6 in “Alternate Functions of Port C” on page 61.
12. Corrected PB6 and PB7 in “Alternate Functions of Port B” on page 58.
13. Corrected 230.4 Mbps to 230.4 kbps under “Examples of Baud Rate Setting”
on page 159.
14. Added information about PWM symmetry for Timer 2 in “Phase Correct PWM
Mode” on page 113.
15. Added thick lines around accessible registers in Figure 76 on page 169.
16. Changed “will be ignored” to “must be written to zero” for unused Z-pointer
bits under “Performing a Page Write” on page 216.
17. Added note for RSTDISBL Fuse in Table 87 on page 223.
18.Updated drawings in “Packaging Information” on page 14.
1.Added errata for Rev D, E, and F on page 17.
1.Changed the Endurance on the Flash to 10,000 Write/Erase Cycles.
1 Updated Table 103, “ADC Characteristics,” on page 248.
20 ATmega8(L)
2486QS–AVR–10/06