AT25256_14 Datasheet, PDF (19/22 Pages) ATMEL Corporation – Low-voltage and Standard-voltage Operation

16S1 – JEDEC SOIC
3
2
1
H
N
Top View
e
B
A
AT25128/256
D
Side View
A2
C
L
E
End View
COMMON DIMENSIONS
(Unit of Measure = mm)
SYMBOL
A
B
C
D
E
e
H
L
MIN
1.35
0.33
0.19
9.80
3.80
5.80
0.40
NOM MAX
–
1.75
–
0.51
–
0.25
–
10.00
–
4.00
1.27 BSC
–
6.20
–
1.27
NOTE
5
2
3
4
Notes: 1. This drawing is for general information only; refer to JEDEC Drawing MS-012 for proper dimensions, tolerances, datums, etc.
2. Dimension D does not include mold Flash, protrusions or gate burrs. Mold Flash, protrusions and gate burrs shall not exceed
0.15 mm (0.006 in) per side.
3. Dimension E does not include inter-lead Flash or protrusions. Inter-lead Flash and protrusions shall not exceed 0.25 mm (0.010 in)
per side.
4. L is the length of terminal for soldering to a substrate.
5. The lead width B, as measured 0.36 mm (0.014 in) or greater above the seating plane, shall not exceed a maximum value of 0.61 mm
(0.024 in).
10/15/01
2325 Orchard Parkway
R _{San Jose, CA 95131}
TITLE
16S1, 16-lead, 0.150" Body,
Plastic Gull Wing Small Outline (SOIC )
DRAWING NO. REV.
16S1
A
19
0872O–SEEPR–03/05