AT91SAM9G10_1 Datasheet, PDF (166/730 Pages) ATMEL Corporation – AT91 ARM Thumb-based Microcontrollers

22.8
Standard Read and Write Protocols
In the following sections, the byte access type is not considered. Byte select lines (NBS0 to
NBS3) always have the same timing as the A address bus. NWE represents either the NWE sig-
nal in byte select access type or one of the byte write lines (NWR0 to NWR3) in byte write
access type. NWR0 to NWR3 have the same timings and protocol as NWE. In the same way,
NCS represents one of the NCS[0..7] chip select lines.
22.8.1
Read Waveforms
The read cycle is shown on Figure 22-8.
The read cycle starts with the address setting on the memory address bus, i.e.:
{A[25:2], A1, A0} for 8-bit devices
{A[25:2], A1} for 16-bit devices
A[25:2] for 32-bit devices.
Figure 22-8. Standard Read Cycle
MCK
A[25:2]
NBS0,NBS1,
NBS2,NBS3,
A0, A1
NRD
NCS
D[31:0]
NRD_SETUP
NRD_PULSE
NCS_RD_SETUP
NCS_RD_PULSE
NRD_CYCLE
NRD_HOLD
NCS_RD_HOLD
22.8.1.1
NRD Waveform
The NRD signal is characterized by a setup timing, a pulse width and a hold timing.
1. NRD_SETUP: the NRD setup time is defined as the setup of address before the NRD
falling edge;
2. NRD_PULSE: the NRD pulse length is the time between NRD falling edge and NRD
rising edge;
3. NRD_HOLD: the NRD hold time is defined as the hold time of address after the NRD
rising edge.
166 AT91SAM9G10
6462A–ATARM–03-Jun-09