SAM-G53G_14 Datasheet, PDF (14/15 Pages) ATMEL Corporation – Atmel | SMART ARM-based Flash MCU

7. Revision History
Table 7-1. SAM G53 Datasheet Rev. 11240DS Revision History
Doc. Rev.
11240DS Changes
Updated document title on first page
Modified operating range minimum value from 1.7V to 1.62V.
“Description”
Added information about low-power modes and Event System.
“Features”
17-Oct-14
Added “on UART and TWI” to “Asynchronous partial wake-up (SleepWalking™)” in “Low power modes (typical value)”
Corrected 4th line under “Peripherals” to read “Two UARTs” (was “Two two-wire UARTs”)
Section 2. “Block Diagram”
Updated Figure 2-1 “SAM G53 Block Diagram”
Section 6. “Ordering Information”
Table 6-1, “Ordering Codes for SAM G53 Devices,”: added ordering codes SAMG53G19B-UUT and SAMG53N19B-AU.
Removed SAMG53N19A-AUT
Table 7-2. SAM G53 Datasheet Rev. 11240CS Revision History
Doc. Rev.
11240CS Changes
04-Jun-14
Updated document title on first page
Minor formatting changes throughout
Section 6. “Ordering Information”
Table 6-1, “Ordering Codes for SAM G53 Devices,”: added prefix ‘AT’ to ordering codes; deleted “(Kbytes)” from
“Package” column header; added “Carrier Type” column
Table 7-3. SAM G53 Datasheet Rev. 11240BS Revision History
Doc. Rev.
11240Bs Changes
06-May-14
Operating voltage range changed to 1.70V to 3.6V throughout.
Figure 2-1 “SAM G53 Block Diagram”: added VDDIO on ADC.
Table 4-3, “SAM G53N19 100-pin LQFP Pinout,”: corrected pin 92 to NC.
Figure 5-1 “49-lead WLCSP Package Mechanical Drawing”: changed values for backside coating and for min of
Total Thickness.
Table 7-4. SAM G53 Datasheet Rev. 11240As Revision History
Doc. Rev.
11240AS Changes
14-Jan-14 First issue
14 SAM G53G / SAM G53N [SUMMARY DATASHEET]
Atmel-11240DS-ATARM-SAM-G53G-SAM-G53N-Summary-Datasheet_17-Oct-14