ATF1504ASVL_14 Datasheet, PDF (11/31 Pages) ATMEL Corporation – High-density, High-performance, Electrically-erasable Complex

ATF1504ASV(L)
DC and AC Operating Conditions
Operating Temperature (Ambient))
V_CC (3.3V) Power Supply
Commercial
0°C - 70°C
3.0V - 3.6V
Industrial
-40°C - 85°C
3.0V - 3.6V
DC Characteristics
Symbol Parameter
Condition
Min
Typ
Max
I_IL
Input or I/O Low
Leakage Current
V_IN = V_CC
-2
-10
I_IH
Input or I/O High
Leakage Current
2
10
I_OZ
Tri-State Output
Off-State Current
V_O = V_CC or GND
-40
40
Com.
60
Std Mode
I_CC1
Power Supply Current,
Standby
V_CC = Max
V_IN = 0, V_CC
Ind.
Com.
75
5
“L” Mode
Ind.
5
I_CC2
I_CC3(2)
Power Supply Current,
Power-down Mode
Reduced-power Mode
Supply Current, Standby
V_CC = Max
V_IN = 0, V_CC
V_CC = Max
V_IN = 0, V_CC
“PD” Mode
Std Power
Com
Ind
0.1
5
40
55
V_IL
Input Low Voltage
-0.3
V_IH
Input High Voltage
1.7
Output Low Voltage (TTL)
V_IN = V_IH or V_IL
V_CCIO = Min, I_OL = 8 mA
Com.
Ind.
V_OL
Output Low Voltage (CMOS)
V_IN = V_IH or V_IL
V_CC = Min, I_OL = 0.1 mA
Com.
Ind.
0.8
V_CCIO + 0.3
0.45
0.45
0.2
0.2
V_OH
Notes:
Output High Voltage
- 3.3V (TTL)
V_IN = V_IH or V_IL
V_CCIO = Min, I_OH = -2.0 mA
2.4
Output High Voltage
- 3.3V (CMOS)
V_IN = V_IH or V_IL
V_CCIO = Min, I_OH = -0.1 mA
V_CCIO - 0.2
1. Not more than one output at a time should be shorted. Duration of short circuit test should not exceed 30 sec.
2. When microcell reduced-power feature is enabled.
Pin Capacitance
C_IN
C_I/O
Note:
Typ
Max
Units
Conditions
8
pF
V_IN = 0V; f = 1.0 MHz
8
pF
V_OUT = 0V; f = 1.0 MHz
Typical values for nominal supply voltage. This parameter is only sampled and is not 100% tested.
The OGI pin (high-voltage pin during programming) has a maximum capacitance of 12 pF.
Units
µA
µA
mA
mA
µA
µA
mA
ma
V
V
V
V
V
V
V
11
1409J–PLD–6/05