T2525_09 Datasheet, PDF (10/12 Pages) ATMEL Corporation – IR Receiver ASSP

8. Ordering Information
Delivering: unsawn wafers (DDW) in box.
Extended Type Number
T2525S0xx⁽¹⁾C-DDW
T2525S1xx⁽¹⁾C-DDW
PL⁽²⁾
2
1
R_PU(3)
30
30
D⁽⁴⁾
2090
2090
Type⁽⁵⁾
Standard type: ≥ 10 pulses, enhanced sensibility, high data rate
Standard type: ≥ 10 pulses, enhanced sensibility, high data rate
T2525S2xx⁽¹⁾C-DDW
2
40
1373
Lamp type: ≥ 10 pulses, enhanced suppression of disturbances, secure
data transmission
T2525S3xx⁽¹⁾C-DDW
1
40
1373
Lamp type: ≥ 10 pulses, enhanced suppression of disturbances, secure
data transmission
T2525S6xx⁽¹⁾C-DDW
T2525S7xx⁽¹⁾C-DDW
2
30
3415 Short burst type: ≥ 6 pulses, enhanced data rate
1
30
3415 Short burst type: ≥ 6 pulses, enhanced data rate
Notes: 1. xx means the used carrier frequency value f₀ 30, 33, 36, 38, 40, 44, 56 kHz. (76 kHz type on request)
2. Two pad layout versions (see Figure 9-1 and Figure 9-2) available for different assembly demand
3. Integrated pull-up resistor at pin OUT (see “Electrical Characteristics”)
4. Typical data transmission rate up to bit/s with f₀ = 56 kHz, V_S = 5V (see Figure 6-3 on page 6)
5. On request: noise type, data rate type
9. Pad Layout
Figure 9-1. Pad Layout 1
GND
IN
OUT
VS
T2525
Fusing
Figure 9-2. Pad Layout 2
(6)
GND ⁽⁵⁾
IN
(1)
VS
(3) _OUT
T2525
Fusing
10 T2525
4657G–AUTO–09/09