|
TSC695F_04 Datasheet, PDF (1/42 Pages) ATMEL Corporation – Rad-Hard 32-bit SPARC Embedded Processor | |||
|
Features
⢠Integer Unit Based on SPARC V7 High-performance RISC Architecture
⢠Optimized Integrated 32/64-bit Floating-point Unit
⢠On-chip Peripherals
â EDAC and Parity Generator and Checker
â Memory Interface
Chip Select Generator
Waitstate Generation
Memory Protection
â DMA Arbiter
â Timers
General Purpose Timer (GPT)
Real-time Clock Timer (RTCT)
Watchdog Timer (WDT)
â Interrupt Controller with 5 External Inputs
â General Purpose Interface (GPI)
â Dual UART
⢠Speed Optimized Code RAM Interface
8- or 40-bit boot-PROM (Flash) Interface
⢠IEEE 1149.1 Test Access Port (TAP) for Debugging and Test Purposes
⢠Fully Static Design
⢠Performance: 20 MIPs/5 MFlops (Double Precision) at SYSCLK = 25 MHz
⢠Core Consumption: 1.0W Typ. at 20 MIPs/0.7W typ. at 10 MIPs
⢠Operating Range: 4.5V to 5.5V(1) -55°C to +125°C
⢠Tested up to Total Dose of 300 KRADs (Si) according to MIL STD 883 Method 1019
⢠SEU Event Rate Better than 3 E-8 Error/Component/Day (Worst Case)
⢠No Single Event Latch-up below an LET Threshold of 80 MeV/mg/cm2
⢠Quality Grades: ESCC with 9512/003 and QML-Q or V with 5962-00540
⢠Package: 256 MQFPF; Bare Die
Note: 1. For 3.3V capability see the TSC695FL datasheet on the Atmel site.
Rad-Hard 32-bit
SPARC
Embedded
Processor
TSC695F
Description
The TSC695F (ERC32 Single-Chip) is a highly integrated, high-performance 32-bit
RISC embedded processor implementing the SPARC architecture V7 specification. It
has been developed with the support of the ESA (European Space Agency), and
offers a full development environment for embedded space applications.
The processor is manufactured using the Atmel 0.5 µm radiation tolerant (⥠300
KRADs (Si)) CMOS enhanced process (RTP). It has been specially designed for
space, as it has on-chip concurrent transient and permanent error detection.
The TSC695F includes an on-chip Integer Unit (IU), a Floating Point Unit (FPU), a
Memory Controller and a DMA arbiter. For real-time applications, the TSC695F offers
a high security watchdog, two timers, an interrupt controller, parallel and serial inter-
faces. Fault tolerance is supported using parity on internal/external buses and an
EDAC on the external data bus. The design is highly testable with the support of an
On-Chip Debugger (OCD), and a boundary scan through JTAG interface.
Rev. 4118JâAEROâ08/04
|
▷ |