PC7410 Datasheet, PDF (1/54 Pages) ATMEL Corporation – PowerPC 7410 RISC Microprocessor Product Specification

Features
• 22.8 SPECint95 (estimated), 17SPECfp95 at 500 MHz (estimated)
• 917MIPS at 500 MHz
• Selectable Bus Clock (14 CPU Bus Dividers Up To 9x)
• Seven Selectable Core-to-L2 Frequency Divisors
• Selectable 603 Interface Voltage Below 3.3V (1.8V, 2.5V)
• Selectable L2 interface of 1.8V or 2.5V
• P_D Typical 5.3W at 500 MHz, Full Operating Conditions
• Nap, Doze and Sleep Modes for Power Saving
• Superscalar (Four Instructions fetched per Clock Cycle)
• 4 GB Direct Addressing Range
• Virtual Memory: 4 hexabytes (2⁵²)
• 64-bit Data and 32-bit Address Bus Interface
• 32 KB Instruction and Data Cache
• Eight Independent Execution Units and Three Register Files
• Write-back and Write-through Operations
• f_INT Max = 450 MHz 500 MHz
• f_BUS Max = 133 MHz
Description
The PC7410 is the second microprocessor that uses the fourth (G4) full implementa-
tion of the PowerPC^™ Reduced Instruction Set Computer (RISC) architecture. It is
fully JTAG-compliant.
The PC7410 maintains some of the characteristics of G3 microprocessors:
• The design is superscalar, capable of issuing three instructions per clock cycle
into eight independent execution units
• The microprocessor provides four software controllable power-saving modes and
a thermal assist unit management
• The microprocessor has separate 32-Kbyte, physically-addressed instruction and
data caches with dedicated L2 cache interface with on-chip L2 tags
In addition, the PC7410 integrates full hardware-based multiprocessing capability,
including a 5-state cache coherency protocol (4 MESI states plus a fifth state for
shared intervention) and an implementation of the new AltiVec^™ technology instruc-
tion set.
New features have been developed to make latency equal for double-precision and
single-precision floating-point operations involving multiplication. Additionally, in mem-
ory subsystem (MSS) bandwidth, the PC7410 offers an optional, high-bandwidth MPX
bus interface.
Unlike the PC7400, the PC7410 does not support the 3.3V I/O on the L2 cache
interface.
PowerPC 7410
RISC
Microprocessor
Product
Specification
PC7410
Rev. 2141D–HIREL–02/04