ATZB-S1-256-3-0-U_14 Datasheet, PDF (1/25 Pages) ATMEL Corporation – ZigBit 2.4GHz Single Chip Wireless Module

ZigBit 2.4GHz Single Chip Wireless Module
ATZB-S1-256-3-0-U / ATZB-S1-256-3-0-UF
DATASHEET
Features
• Ultra compact size (30.0 × 20.0mm)
• High RX sensitivity (-98dBm)
• Outperforming link budget (up to 102dB)
• Up to +4dBm output power
• Very low power consumption:
• 17mA in RX mode ⁽¹⁾
• 16.4mA in TX mode ⁽¹⁾
• 0.6µA in sleep mode ⁽²⁾
• Ample memory resources (256K Bytes In-System, Self-Programmable Flash
memory, 8K Bytes EEPROM, 32K Bytes SRAM)
• Wide range of interfaces (both analog and digital)
• 4-wire SPI, TWI
• ISP, JTAG
• Two Analog comparator Input
• UART, USART
• Timer, PWM
• Four ADC lines
• External Clock Input, Internal Clock Output
• Upto 31 lines configurable as GPIO
• Preassigned Atmel MAC address that can be used on end product
• Capability to use MAC address into the internal EEPROM
• IEEE^® 802.15.4 compliant Transceiver
• 2.4GHz ISM band
• Serial bootloader
• High Performance Low power Atmel AVR^® 8-bit Microcontroller
• U.FL Antenna Connector to select approved antennae upto 5dBi
• Small physical footprint and low profile for optimum fit in very small application
boards
• Mesh networking capability
• Easy-to-use low cost development kit
• Single source of support for HW and SW
• Worldwide license-free operation
Notes: 1. MCU is in active state with 3V Supply, CPU clock @ 16MHz, RX RPC enabled (for RX current),
PHY_TX_PWR=0x0 (for TX current), All digital outputs pulled high.
2. Controller Sleep Mode: SLEEP_MODE_PWR_DOWN.
42199B−WIRELESS−04/2014