ATZB-RF-233-1-C_14 Datasheet, PDF (1/22 Pages) ATMEL Corporation – ZIGBIT 2.4GHZ WIRELESS MODULES

ZIGBIT 2.4GHZ WIRELESS MODULES
ATZB-RF-233-1-C
DATASHEET
Features
• Ultra Compact size (25.0 x 20.0mm)
• Built In Front End Module to boost Output power upto +20dBm with Integrated
LNA for increased Sensitivity
• MCU less Tranceiver module with SPI interface
• High RX sensitivity (-104dBm)
• Outperforming link budget (up to +124dB)
• Up to +20.5dBm output power
• Very low power consumption:
• 7.5mA in RX mode ⁽¹⁾
• 157mA in TX mode ⁽¹⁾
• 0.7µA in sleep mode⁽²⁾
• Internal Clock Output
• Preassigned Atmel^® MAC address that can be used on end product
• Capability to use MAC address into the onboard EEPROM
• IEEE^® 802.15.4 compliant Transceiver
• 2.4GHz ISM band
• Rapid design-in with built-in Chip Antenna
• RF Test point using MS-147 RF connector
• Small physical footprint and low profile for optimum fit in very small application
boards
• Mesh networking capability
• Easy-to-use low cost development kit
• Single source of support for HW and SW
• Worldwide license-free operation
Note:
Note:
1. MCU is in active state with 3V Supply, CPU clock @ 16MHz, RX RPC enabled (for RX current),
PHY_TX_PWR=0x0 (for TX current), All digital outputs pulled high.
2. Controller Sleep Mode – SLEEP_MODE_PWR_DOWN
4 21 92 B−W I REL ESS−03 /2 01 4