ATTINY13 Datasheet, PDF (1/169 Pages) ATMEL Corporation – 8-bit AVR Microcontroller with 1K Bytes In-System Programmable Flash

Features
• High Performance, Low Power AVR^® 8-Bit Microcontroller
• Advanced RISC Architecture
– 120 Powerful Instructions – Most Single Clock Cycle Execution
– 32 x 8 General Purpose Working Registers
– Fully Static Operation
• Non-volatile Program and Data Memories
– 1K Byte of In-System Programmable Program Memory Flash
Endurance: 10,000 Write/Erase Cycles
– 64 Bytes In-System Programmable EEPROM
Endurance: 100,000 Write/Erase Cycles
– 64 Bytes Internal SRAM
– Programming Lock for Self-Programming Flash Program and EEPROM Data
Security
• Peripheral Features
– One 8-bit Timer/Counter with Prescaler and Two PWM Channels
– 4-channel, 10-bit ADC with Internal Voltage Reference
– Programmable Watchdog Timer with Separate On-chip Oscillator
– On-chip Analog Comparator
• Special Microcontroller Features
– debugWIRE On-chip Debug System
– In-System Programmable via SPI Port
– External and Internal Interrupt Sources
– Low Power Idle, ADC Noise Reduction, and Power-down Modes
– Enhanced Power-on Reset Circuit
– Programmable Brown-out Detection Circuit
– Internal Calibrated Oscillator
• I/O and Packages
– 8-pin PDIP/SOIC: Six Programmable I/O Lines
• Operating Voltage:
– 1.8 - 5.5V for ATtiny13V
– 2.7 - 5.5V for ATtiny13
• Speed Grade
– ATtiny13V: 0 - 6 MHz @ 1.8 - 5.5V, 0 - 12 MHz @ 2.7 - 5.5V
– ATtiny13: 0 - 12 MHz @ 2.7 - 5.5V, 0 - 24 MHz @ 4.5 - 5.5V
• Industrial Temperature Range
• Low Power Consumption
– Active Mode:
1 MHz, 1.8V: 240µA
– Power-down Mode:
< 0.1µA at 1.8V
Pin Configurations
Figure 1. Pinout ATtiny13
PDIP/SOIC
(PCINT5/RESET/ADC0/dW) PB5 1
(PCINT3/CLKI/ADC3) PB3 2
(PCINT4/ADC2) PB4 3
GND 4
8 VCC
7 PB2 (SCK/ADC1/T0/PCINT2)
6 PB1 (MISO/AIN1/OC0B/INT0/PCINT1)
5 PB0 (MOSI/AIN0/OC0A/PCINT0)
8-bit
Microcontroller
with 1K Bytes
In-System
Programmable
Flash
ATtiny13
Preliminary
Rev. 2535B–AVR–01/04