ATA5823_06 Datasheet, PDF (1/98 Pages) ATMEL Corporation – UHF ASK/FSK Transceiver

Features
• Full-duplex Operation Mode without Duplex Frequency Offset to Prevent the Relay
Attack against Passive Entry Go (PEG) Systems
• High FSK Sensitivity: –105.5 dBm at 20 Kbit/s/–109 dBm at 2.4 Kbit/s (433.92 MHz)
• High ASK Sensitivity: –111.5 dBm at 10 Kbit/s/–116 dBm at 2.4 Kbit/s (100% ASK,
Carrier Level 433.92 MHz)
• Low Supply Current: 10.5 mA in RX and TX Mode (3V/TX with 5 dBm/433.92 MHz)
• Data Rate 1 to 20 Kbit/s Manchester FSK, 1 to 10 Kbit/s Manchester ASK
• ASK/FSK Receiver Uses a Low IF Architecture with High Selectivity, Blocking and Low
Intermodulation (Typical 3 dB Blocking 55.5 dBC at ±750 kHz/60.5 dBC at ±1.5 MHz and
67 dBC at ±10 MHz, System I1dBCP = –30 dBm/System IIP3 = –20 dBm)
• Wide Bandwidth AGC to Handle Large Outband Blockers above the System I1dBCP
• 226 kHz IF (Intermediate Frequency) with 30 dB Image Rejection and 220 kHz System
Bandwidth to Support TPM Transmitters using ATA5756/ATA5757 Transmitters with
Standard Crystals
• Transmitter Uses Closed Loop FSK Modulation with Fractional-N Synthesizer with
High PLL Bandwidth and an Excellent Isolation between PLL and PA
• Tolerances of XTAL Compensated by Fractional-N Synthesizer with 800 Hz RF
Resolution
• Integrated RX/TX-Switch, Single-ended RF Input and Output
• RSSI (Received Signal Strength Indicator)
• Communication to Microcontroller with SPI Interface Working at 500 kBit/s Maximum
• Configurable Self Polling and RX/TX Protocol Handling with FIFO-RAM Buffering of
Received and Transmitted Data
• 1 Push Button Input and 1 Wake-up Input are Active in Power-down Mode
• Integrated XTAL Capacitors
• PA Efficiency: up to 38% (433.92 MHz/10 dBm/3V)
• Low In-band Sensitivity Change of Typically ±2.0 dB within ±75 kHz Center Frequency
Change in the Complete Temperature and Supply Voltage Range
• Fully Integrated PLL with Low Phase Noise VCO, PLL Loop Filter and full support of
multi-channel operation with arbitrary Channel distance due to Fractional-N
Synthesizer
• Sophisticated Threshold Control and Quasi-peak Detector Circuit in the Data Slicer
• 433.92 MHz, 868.3 MHz and 315 MHz without External VCO and PLL Components
• Efficient XTO Start-up Circuit (> –1.5 kΩ Worst Case Start Impedance)
• Changing of Modulation Type ASK/FSK and Data Rate without Component Changes to
Allow Different Modulation Schemes in TPM and RKE
• Minimal External Circuitry Requirements for Complete System Solution
• Adjustable Output Power: 0 to 10 dBm Adjusted and Stabilized with External Resistor,
Programmable Output Power with 0.5dB Steps with Internal Resistor
• Clock and Interrupt Generation for Microcontroller
• ESD Protection at all Pins (±2.5 kV HBM, ±200V MM, ±500V FCDM)
• Supply Voltage Range: 2.15V to 3.6V or 4.4V to 5.25V
• Typical Power-down Current < 10 nA
• Temperature Range: –40°C to +105°C
• Small 7 mm × 7 mm QFN48 Package
UHF ASK/FSK
Transceiver
ATA5823
ATA5824
4829D–RKE–06/06