|
ATA5745C_14 Datasheet, PDF (1/42 Pages) ATMEL Corporation – UHF ASK/FSK Receiver | |||
|
ATA5745C/ATA5746C
UHF ASK/FSK Receiver
DATASHEET
Features
â Transparent RF receiver ICs for 315MHz (Atmel® ATA5746C) and 433.92MHz
(Atmel ATA5745C) with high receiving sensitivity
â Fully integrated PLL with low phase noise VCO, PLL, and loop filter
â High FSK/ASK sensitivity:
â â105dBm (Atmel ATA5746C, FSK, 9.6Kbits/s, Manchester, BER 10-3)
â â114dBm (Atmel ATA5746C, ASK, 2.4Kbits/s, Manchester, BER 10-3)
â â104dBm (Atmel ATA5745C, FSK, 9.6Kbits/s, Manchester, BER 10-3)
â â113dBm (Atmel ATA5745C, ASK, 2.4Kbits/s, Manchester, BER 10-3)
â Supply current: 6.5mA in Active Mode (3V, 25°C, ASK Mode)
â Data rate: 1Kbit/s to 10Kbits/s Manchester ASK, 1Kbit/s to 20Kbits/s Manchester
FSK with four programmable bit rate ranges
â Switching between modulation types ASK/FSK and different data rates possible in
⤠1ms typically, without hardware modification on board to allow different
modulation schemes for RKE, TPMS
â Low standby current: 50µA at 3V, 25°C
â ASK/FSK receiver uses a Low-IF architecture with high selectivity, blocking, and
Low intermodulation (typical 3-dB blocking 68.0dBC at ±3MHz/74.0dBC at
±20.0MHz, system I1dBCP = â31dBm/system IIP3 = â24dBm)
â Telegram pause up to 52ms supported in ASK Mode
â Wide bandwidth AGC to handle large out-of-band blockers above the system
I1dBCP
â 440-kHz IF frequency with 30-dB image rejection and 420-kHz IF bandwidth to
support PLL transmitters with standard crystals or SAW-based transmitters
â RSSI (Received Signal Strength Indicator) with output signal dynamic range of
65dB
â Low in-band sensitivity change of typically ±2.0dB within ±160-kHz center
frequency change in the complete temperature and supply voltage range
â Sophisticated threshold control and quasi-peak detector circuit in the data slicer
â Fast and stable XTO start-up circuit (> â1.4kΩ worst-case start impedance)
â Clock generation for microcontroller
9249C-RKE-10/14
|
▷ |