|
ATA5283 Datasheet, PDF (1/14 Pages) ATMEL Corporation – Interface IC for 125 kHz Wake-up Function | |||
|
Features
⢠Wake-up Function for a Microcontroller with Preamble Detection
⢠1 mVrms Sensitivity
⢠1 µA Standby Current
⢠Power Supply: 2 V to 3.8 V
⢠Baud Rate: up to 4 kbps (ASK Modulation)
⢠Operation Temperature: up to 125°C
⢠Withstands +175°C
⢠Few External Components
Application
⢠Tire Pressure Monitoring (TPM)
Description
The ATA5283 is a 125 kHz ultra-low power receiver used for the wake-up function of
Tire Pressure Monitoring (TPM) application. The sensitive input stage of the IC ampli-
fies and demodulates the carrier signal from the antenna coil to a digital output signal
for a microcontroller. During the standby mode the preamble detection unit monitors
the incoming signal and activates the wake-up output and the data output, if the IC
receives a proper 125 kHz carrier signal.
By combining the IC with an antenna coil, a microcontroller, an RF transmitter/trans-
ceiver, a battery, temperature- and pressure sensor, it is possible to design a
complete Tire Pressure Monitoring system (TPM).
Figure 1. Block Diagram
Interface IC for
125 kHz
Wake-up
Function
ATA5283
Preliminary
Battery
Lx
Amplifier
with AGC
COIL
VDD
ATA5283
RESET
Vref
TST1
TST2
Condi-
tioner
Preamble
check
N_WAKEUP
N_DATA
GND
Rev. 4598DâAUTOâ03/04
|
▷ |